Door trigger for 2000 Honda Accord SE
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=30337
Printed Date: May 16, 2024 at 3:17 AM
Topic: Door trigger for 2000 Honda Accord SE
Posted By: dominos911
Subject: Door trigger for 2000 Honda Accord SE
Date Posted: April 14, 2004 at 9:46 AM
This may have been addressed in other posts, but I have not found an answer. I installed the viper 560xv, but the car self arms even though one of the doors are opened. I connected the door trigger of the alarm to the BLACK/ white wire that was provided by this forum. So do I have to put diodes in every door, is there a simpler way to do this, or did I connect it to the wrong wire? Thanks for the info!
Replies:
Posted By: raydawg357
Date Posted: April 14, 2004 at 10:16 AM
You should have caught the BLACK/ white (-) wire in the passenger fuse box. It's in a green 4 pin connector. It doesn't need a diode. Make sure you have it connected to the negative door trigger wire and not the positive.
-------------
Do it right the first time
Posted By: dominos911
Date Posted: April 14, 2004 at 10:27 AM
raydawg357
That is where I connected it. BTW this car has a factory security system on it already.
Posted By: raydawg357
Date Posted: April 14, 2004 at 10:34 AM
It shouldn't matter about the factory security system. Are all of your door triggers good? you might have a bad one that's reading (+) instead of (-). Also, is your dome light switch set to door? I've experienced some cars giving a false reading if it's switched to off.
-------------
Do it right the first time
Posted By: dominos911
Date Posted: April 14, 2004 at 10:45 AM
I have the domelight switch to door. I will take a another look. Thanks
|