Valet Switch Problem, help!!!

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=30391
Printed Date: June 18, 2025 at 6:51 PM

Topic: Valet Switch Problem, help!!!

Posted By: tadziu2001
Subject: Valet Switch Problem, help!!!
Date Posted: April 14, 2004 at 10:12 PM

Hello,

I have a question about a problem i am having with my alarm. It is a Mega-3600 . Anyways, i have it partially hooked up, but when i try to get into the programing, like turn the key on and off 3 times, then hit the valet switch ### of times & hold it down, then the alarm should chirp back a # of chirps confirming that i entered the mode... But instead of that it chirps once and pages my remote. I am totally lost and dont know what to do next. I dont know where to start... Thank you!!!!

Replies:

Posted By: Teamrf
Date Posted: April 14, 2004 at 10:16 PM

What I would do is re-read your programming instructions.. Just sit there and actually think about whats going on. Hope that helps.

-------------
~The Rookie~
Rookie of the year that is...
Don't let the smoke out of your equiptment..it doesn't go back in.

Posted By: desh187
Date Posted: April 15, 2004 at 12:14 AM

usually i put the system in valet mode for a few seconds and then out of valet.
after that try programming your remotes if they are not programmed and turning the ignition on and off should also be done quickly eg ignition on is two clicks up from off position and off is just 1 click back.

Posted By: CutDog504
Date Posted: April 15, 2004 at 12:30 AM

Also, make sure your ignition wire and door trigger are both hooked up already.

Print Page | Close Window