I just installed a CS2015 in my 98 Dakota. I had the locks working perfectly from the remote and the lock switches themselves. I used the 5 wire Alternating 12V positive setup. I started the truck and the doors locked, urned it off and they unlocked. Everything was perfect. Then I tucked everything out of the way took the truck for a little drive and when I got home then locks didn't work from the door switch or the remote. I looked to see if any of the wires were grounded or anything, but nothing. When I pushed the button on the remote you can hear the relays click. Both lock and unlock didn't work. So then I looked at the fuse in the fuse panel. It was blown and I don't know why. So I replaced it and tied the switch on the door and pop again the fuse blows. I don't get it? The locks worked fine for the first 10 tries and now both the lock and unlock don't work. Any ideas???
Rob 98 Dakota
is this the info that you used???
Power Lock ORN/PPL OR GRN/BLK 16 PIN CONNECTOR BEHIND ** #203
Power Unlock PINK/VIOLET FUSE BLOCK IN DRIVER KICK PANEL
** ORANGE / VIOLET Wire Changes To L GREEN/ BLACK In The 16 Pin Connector Behind The Fuse Block In The Driver Kick Panel. #203 - See Reversal Rest At Ground Door Lock Diagram W/Or WO Keyless.
https://wiringinstructions.com/203.htm-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt