Print Page | Close Window

CT-5000 Programming Problem

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=30482
Printed Date: May 09, 2025 at 10:54 AM


Topic: CT-5000 Programming Problem

Posted By: pilotcam
Subject: CT-5000 Programming Problem
Date Posted: April 16, 2004 at 9:26 AM

I seem to be having a problem getting a new CT-5000 into a programming mode to accept a remote.  The unit powers up and immediately goes into alarm as expected.  But when i do the "hold hood pin switch down for four seconds", the parking lights just keep flashing.  Sometimes it will respond with a slightly longer flash, but when I try the next step, the "push and release", they just keep flashing. After a minute or so when the alarm quits, I try again, and the pin switch release after the four seconds triggers the alarm again.

I tried stripping everything down to bare bones... I connected only the two red battery wires, the ground wire, and the hood switch with an alligator clip to ground.  Nothing changes.. defective brain perhaps??

Any input is appreciated.

Cam




Replies:

Posted By: derek123
Date Posted: April 16, 2004 at 10:42 AM

enter then exit VALET MODE.

then procede with remote coding.




Posted By: pilotcam
Date Posted: April 16, 2004 at 12:22 PM

Thanks, I'll give that a try.

Cam


Print Page | Close Window