proximity sensor + window roll up

i've got a DEI python 6000 esp, dei 530t and a clifford proximity sensor hooked up to my car. everything works fine. i was just wondering how would i have the window roll up (if armed and vented) when the proximity sensory stage 1 was triggered (warn away). anyone has done this and would like to share this information? thanks

hey jon, did you figure it out?  I think I've read stuff before on here about rolling up when the stage 1 was triggered, so was wondering if you have found any of it?

well to answer your question cpgoose, no i haven't figured it out, hopefully someone in the 12v will know. anyways i know how to vent the windows when the system is armed, and i hooked up the sensor shunt on correctly so that the windows going up wont trigger the proximity sensor while it is arming. ill try to make myself more clear. well, btw my alarm is a 3000 they dont make 6000 esp pythons, my proximity sensor triggers and turns on the piezo siren for about 1sec when some one comes close enough to peek in. if i had my windows rolled down (vented) when it is armed and someone peeked in to trigger the warn away zone, which wires would i hook up to the window module to roll the windows up when the warn away zone was triggered.

i was thinking hook up the negative wire that goes to my piezo siren inline with a diode to the negative armed when output wire on the window module. but i can be wrong, anyone has any idea. well if not then your gonna have to wait till the weekend when i have the time to play with it cpgoose. when i find out i'll post it.

well first of all, i have four windows that means i have to hook it up manually to all four of the up switches. hmmm.....i don't know. well that sounds like a  good idea anyways.k when i arm the alarm all four windows roll up at the same time with just one output from the brain. i would like it my windows to roll up using a centralized output, instead of it splitting out to 4 of my windows. 

well i was reasearching and when the system is armed, armed when output supplies constant negative. with the diode in place, negative pulse is blocked from going to the window module. so if i supply a negative after the diode before the window module then the window should roll up. ill give it a try but it sounds right? what do you think?

https://www.directed.com/guides/pdfs/N381P.pdf page4 starterkill; https://www.the12volt.com/diodes/diodes.asp

Well yes, you would have to tap into all four switches, but all that would require is four diodes and a few minutes, since you could tie it in right at the module. 

I do not think that sending a negtive pulse to the ground when armed lead after the diode would make a difference, because it reads a constant ground already, so what would sending a negative pulse to a constant groud accomplish?  I imagine that one of the relay gurus here at the 12volt could draw you up a digram of how to have the negative pulse from your proximity sensor trip a relay setup to turn the constant ground off and then back on again, and that would do it, but wouldn't it just be easier to go with the scenario I gave you before?  Have fun with it.

the easiest thing to do , is to run the neg. with a diode , form the warn away to a timer relay ,and wire the timer relay to the neg activation wire of the window modules . adjust the timer so it activates just long enough to roll all the windows up .