2004 Dodge truck

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=30812
Printed Date: May 11, 2024 at 9:06 PM

Topic: 2004 Dodge truck

Posted By: rtezino
Subject: 2004 Dodge truck
Date Posted: April 21, 2004 at 5:22 PM

Do anyone know how to wire a relay for the parking light output for a 2004 dodge truck.It needs - polarity for parking lights to work.Please tell me the pin out connections for the - polarity parking lights.Thanks for your help.

Replies:

Posted By: 1kewlexpo
Date Posted: April 21, 2004 at 5:55 PM

I used the WHITE/ gray (+) wire in the engine compartment. It's the wiring harness by the firewall, close to the driver side fender, by the brake master cylinder. This will flash all of the parking lights for you.

John

Posted By: auex
Date Posted: April 21, 2004 at 8:07 PM

- trigger through a 330 ohm resistor. If your alarm only supplies a +12V then use the diagram below and place the resistor inline with the output.

posted_image

-------------
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.

I've been sick lately, sorry I won't be on much.

Print Page | Close Window