2004 Dodge Ram Diesel Remote Start

Does anyone have an alarm and remote start wiring diagram for a 2004 Dodge Ram Diesel? (it's actually 2004 1/2, if that 1/2 a year makes a difference.)  Thank you in advance, it's greatly appreciated.

I still have the same as the 2004

Dodge

Ram Pickup

2002-2004

Remote Starter  Wiring Colors and Notes
Function		Vehicle  Color	Location
Start:		YELLOW	IGNITION SWITCH HARNESS
Ignition  #1:		BLUE (16 AWG)	IGNITION SWITCH HARNESS
Ignition #2:		RED	IGNITION SWITCH HARNESS
Ignition  #3:		GREEN & ORANGE (2 WIRES)	IGNITION SWITCH HARNESS
Accessory:		BLACK/ WHITE & BLUE (2 WIRES)	IGNITION SWITCH HARNESS
Brake  Light:		WHITE/ TAN	AT SWITCH ABOVE BRAKE PEDAL
Tach  Signal:		TAN/RED	AT IGNITION COIL
Parking Lights:		PURPLE / YELLOW	HEADLIGHT SWITCH*
Headlights:		PURPLE / YELLOW	HEADLIGHT SWITCH *
OEM Alarm  Disarm:		LT. GREEN/ ORANGE *****	HARNESS COMING IN FROM DRIVER'S DOOR
OEM Alarm  Arm:
Diesel  Glow Plug:		ORANGE / Black	Powertrain Control Module***
Clutch  Bypass Wire:
Notes:		* This Is A Single Wire System. Parking Lights Need To See A Ground (-) Through A 330 Ohm Resistor. Headlights Need To See A Ground (-) Through A 700 Ohm Resistor. ** Diesel Vehicles - ORANGE / Black Wait to Start; Tach Wire Is Gray/Black. Both Wires Are Located In A Black Connector Center Top Of Fire Wall. There Are Two Black Connectors, The Correct One Does Not Have A White Insert. *** Tach can also be located at pin 74 behind instrument cluster.

---

Dodge

Ram Pickup

2002-2004

Alarm and Keyless  Entry Wiring Colors and Notes
Function		Vehicle  Color	Location
Constant  +12 Volts:		PINK/BLACK	IGNITION SWITCH HARNESS
Starter  Kill:		YELLOW	IGNITION SWITCH HARNESS
Ignition  +12 Volts:		BLUE (16 AWG)	IGNITION SWITCH HARNESS
Dome  Lights/Superv:		SEE NOTE ***
OEM Horn:		BLACK/ RED (-)	STEERING COLUMN HARNESS
Power  Lock:		WHITE/ GREEN	DRIVER'S KICK PANEL ****
Power  Unlock:		WHITE/ GREEN	DRIVER'S KICK PANEL ****
Trunk  Release:		N/A
Alarm  Input Wire:		SEE NOTE ***
Notes:		*** Separate Triggers For Each Door. The Driver's Door Trigger Is Tan (-). The Left Rear Door Trigger Is Tan/Orange (-). Both Wires Can Be Found In The Driver's Kick Panel. The Passenger Front Door Trigger Is Tan/Red (-) And the Passenger Rear Door Trigger Is Tan / YELLOW (-). Both Of These Wires Can Be Found In The Passenger Kick Panel. Diode Isolate Each Wire For Alarm Trigger With The Bands Facing Away From The Alarm/Remote Start Module. Use Only One Trigger For Dome Light Supervision. **** Single Wire Door Lock System See Note #211. Lock Requires A Ground (-) Pulse Through A 867 Ohm Resistor. Unlock Requires A Ground (-) Pulse Through A 364 Ohm Resistor. Diode Isolate One Of The Wires. ***** Requires A Negative Pulse Through A 1.5 K-Ohm Resistor.

-------------
"Big" Mike
Double Take
Fremont, Ne
remember to check all your wires with a dmm not a test light!!
i take no responsibilty whatsoever for the vailidty of the info nor consequences thereof

For some reason the software bmf1000d uses actually thinks an 04 is the same as the 02-03 Rams. They are different. This is for an 04.


04 Ram
12volts      red (x2)       +       ignition harness
Starter      yellow       +       ignition harness
Ignition      pink/white       +       ignition harness
Second Ignition      pink/lt. green       +       ignition harness
Accessory      dk. blue & pink/yel (16 awg)       +       ignition harness
Second Accessory      pink / YELLOW (14 awg)       +       ignition harness

Power Lock      PURPLE / dk. green       -       driver kick, door harness
Notes: Lock is negative trigger thru an 820 ohm resistor. Unlock is negative trigger thru a 330 ohm resistor. MUST use relays.
Power Unlock      same wire as power lock              

Parking Lights+      wht/yel (L), wht/gray (R)       +       harness at top of driver fender
Parking Lights-      WHITE/ lt. green       -       headlight switch
Notes: Parking lights are negative trigger thru a 249 or 330 ohm resistor. MUST use a relay.

Door Trigger      see notes       -       see notes
Notes: The driver door trigger is purple and the driver side rear door is PURPLE / orange. These wires are in the driver kick panel. The passenger door trigger is PURPLE / white and the passenger side rear door is purple / YELLOW. These wires are in the passenger kick panel. Use all four wires and diode isolate each. See DirectFax document 1076 for wiring information.
Dome Supervision      use door trigger wire
               
Factory Alarm Arm      PURPLE / lt. blue       -       driver kick, door harness
Notes: This will also do door locks. Arm/lock is negative trigger thru a 2K ohm resistor. Disarm/unlock is negative trigger thru a 480 ohm resistor. Single pulse will do disarm without unlocking the doors. Unlock requires a double pulse. MUST use relays.
Factory Alarm Disarm      same wire as factory alarm arm      
      
Tachometer      dk. blue/gray       ac       PCM, orange plug, pin 34
Notes: The PCM is on the passenger side firewall. On diesel models the tach wire is at the ECM on the lower driver side of the engine, 60 pin plug, pin 24.
Wait to start      see document 1091              
Brake Wire      WHITE/ tan       +       brake pedal switch
Parking Brake      dk. GREEN / WHITE       -       parking brake switch
Horn Trigger      dk. GREEN/ purple       -       steering column
Immobilizer Bypass Module:     Required: Yes     Type: Sentry Key     Part #: 555C or 555U
Notes: Only vehicles with gray keys have the immobilizer.

Thanks for all the help... you guys rock.