clifford solaris crank time

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=30854
Printed Date: May 17, 2025 at 12:41 PM

Topic: clifford solaris crank time

Posted By: Big Raz
Subject: clifford solaris crank time
Date Posted: April 22, 2004 at 2:27 PM

anyone know how i can adjust the crank time for the remote start on the clifford solaris i've got the cliffnet wizard which works fine but the crank time option is greyed out.

also my windows are very slow when closing so the total closure gets stuck anyting i can do to speed them up?

Thanks in advance

Replies:

Posted By: Teamrf
Date Posted: April 22, 2004 at 2:39 PM

On the crank time you should have a programming menu just go there using that pin switch.

-------------
~The Rookie~
Rookie of the year that is...
Don't let the smoke out of your equiptment..it doesn't go back in.

Posted By: Big Dog
Date Posted: April 22, 2004 at 2:39 PM

Solaris G4 or G5? Either way it's hooked up to a IS4.
Did you try the Wizard in offline mode?
Does it still show the same?

Are you using SmartWindows 4?
Did you do the auto-learn routine?
Is it the windows that are binding?
Do they go up OK using the OEM switch?
How about if you try to raise them using the manual control in the Wizard?

-------------
Prepare your future. It wasn't the lack of stones that killed the stone age.

Posted By: Big Raz
Date Posted: April 22, 2004 at 3:15 PM

its the g4 the windows go up ok with the switch and i'm using the total closure madule not smart withdows how do i do an auto learn routine and what do u mean by binding?

i'm not using intelli start the fuction is built in to this model i can see the option in offline mode

Posted By: Big Raz
Date Posted: April 27, 2004 at 4:12 PM

is anybody there??? posted_image

Posted By: scirocco16v
Date Posted: April 28, 2004 at 12:00 AM

i don't think solaris will let you adjust crank time if you have it set for tach monitoring, you shouldn't need to if you are using a tach. I've seen the closure models do this on vehicles with slow moving windows. Other then taking some of that load off the motor by whatever is causing it, I don't no what to do. However, I have seen smart windows react very well to slow windows to the point they almost stopped, but the module still knew when they were all the way up.

Posted By: Big Raz
Date Posted: May 02, 2004 at 8:33 AM

the starter option at the top in clifford wiz is greyed out so i can't access any setting in online mode but i can see the option in offline mode. the only setting i can change are in the user tab then the display remote starter settings button.

Posted By: Big Raz
Date Posted: May 02, 2004 at 8:35 AM

i'm in the UK if there is any difference in models here?