Print Page | Close Window

mannix/2000 accord door sensor/dome light

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=31023
Printed Date: September 18, 2025 at 9:48 PM


Topic: mannix/2000 accord door sensor/dome light

Posted By: sgtjnelson
Subject: mannix/2000 accord door sensor/dome light
Date Posted: April 25, 2004 at 9:29 PM

i have a 2000 v6 accord 4 dr lx. recently purchased mannix remote start car alarm. im having trouble with completing the circuit correctly for the door sensors and dome light. as of now when alarm is armed the door on the lcd pager flashes and the siren sounds shortly after. the alarm seems to not recognize that the door is secured. also the srs light on instrument panel stays lit. can anyone help me please...all replies are welcome...thank you in advance



Replies:

Posted By: raydawg357
Date Posted: April 26, 2004 at 8:05 AM

Your door pin is in the passenger side fuse box:  BLACK/ white (-)

HONDA, ACCORD, 2000, Door Trigger

In a green 4 pin connector.

If you already have this wire tapped, check your door pins and make sure they are all good.  Also, check to make sure your hood pin switch is adjusted correctly.



-------------
Do it right the first time




Posted By: Velocity Motors
Date Posted: April 26, 2004 at 9:44 AM
SRS light is because of an ignition wire not being powered up properly when remote started. You will need to reset this error from the dealership or manually. Make sure that you used the correct door trigger input wire on the alarm harness. Most systems come with 2 door input wires, one for (+) type systems and one for (-) type systems, in this case you should have used the (-) input wire for the Accord.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA




Posted By: sgtjnelson
Date Posted: April 26, 2004 at 7:48 PM

 do you think that the srs light is on because i took out the drivers seat and had to disconnect a connector that was part of the srs to do that.

also with this BLACK/ white wire ...do i cut in half from fuse box and run one end to 30 on the relay and the other to 87a...if so which end goes to which

i appreciate your guys help...it was much needed...thank you






Print Page | Close Window