location of wire harness

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=31202
Printed Date: May 18, 2025 at 3:22 PM

Topic: location of wire harness

Posted By: firewin
Subject: location of wire harness
Date Posted: April 28, 2004 at 7:03 AM

i would like to know where is the location of the wire harness of toyota camry 2000 LE so i can tap a keyless entry to it? is it inside the drivers door panel or under the steering wheel. thank you

Replies:

Posted By: Velocity Motors
Date Posted: April 28, 2004 at 7:37 AM

The lock wires are about 18 gauge. They will test only by operating the key in the passenger door lock cylinder, not the rocker switch on the door itself.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA

Posted By: firewin
Date Posted: April 29, 2004 at 5:18 AM

is the location of fusebox beside the steering wheel?

Posted By: eurotech
Date Posted: April 29, 2004 at 12:50 PM

It should be under your dash to the left of the steering wheel. If you have the owners manual (for the car) it will tell you in there. I would run a constant wire from either the battery or the ignition harness (located under the steering wheel, maybe a little to the right of it...with big wires in it) 12v constant is a large white wire in that harness, ignition is BLACK / YELLOW in the same harness (you will need that too). Make sure you fuse these connections.

Posted By: firewin
Date Posted: May 03, 2004 at 5:08 AM

eurotech wrote:

It should be under your dash to the left of the steering wheel. If you have the owners manual (for the car) it will tell you in there. I would run a constant wire from either the battery or the ignition harness (located under the steering wheel, maybe a little to the right of it...with big wires in it) 12v constant is a large white wire in that harness, ignition is BLACK / YELLOW in the same harness (you will need that too). Make sure you fuse these connections.

thank you. ill try to check it out.