Print Page | Close Window

96 Accord With Pheonix Digital 2-way

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=31809
Printed Date: November 21, 2025 at 10:28 PM


Topic: 96 Accord With Pheonix Digital 2-way

Posted By: krutoy
Subject: 96 Accord With Pheonix Digital 2-way
Date Posted: May 08, 2004 at 10:37 AM

Can someone help me where to find the alternator field wire or the oil wire. I have a 96 Accord EX I looked for hours can find it sorry im a newbie. Can someone please tell me the location of this wire or is there another wire i can hook it up to remote start? Please tell me the location of these wires sorry very new to this.

Thanks in Advance




Replies:

Posted By: jrilla
Date Posted: May 08, 2004 at 4:47 PM
I installed one of those for a friend and was purdy confused with that wire since 99.9% of starters on the martket use a tach input. I am almost positive I found the oil wire but it didnt work, so I found out that using 12v+ constant works for that wire. I am guessing by connecting that wire to 12v+ constant the unit just uses a timer for the stater wire. It may not be the greatest solution since I am not sure what would happen if the car did not start the first time like if it was really cold, but it will work. Another thought I had was that by connecting that wire to the 12v+ constant wire at the main ignition harness, the unit uses the wire as a voltage sensing circuit. If that is true then the wire would monitor the voltage on the power wires and look for a jump in voltage once the alternator kicked on. That would be better than just a timer, but still not as reliable as a tach source.

-------------
J Rilla

Owner/Installer


Print Page | Close Window