DEI 530T Window Doesn’t Roll All Way Up
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=31815
Printed Date: January 31, 2026 at 9:24 PM
Topic: DEI 530T Window Doesn’t Roll All Way Up
Posted By: yelloboi1
Subject: DEI 530T Window Doesn’t Roll All Way Up
Date Posted: May 08, 2004 at 1:29 PM
I just installed a DEI 530T Power Window module for my 97 Supra to compliment the RSX 3.5 I have. Everything works fine, but when I arm the alarm, the Passenger side window stops about half an inch from fully closed (right when the glass touches the rubber), but the Driver's side goes all the way up. I would really appreciate anyone has. I'm kind of a novice at alarms. In fact, this is the first one I did! Thanks.
Replies:
Posted By: JWorm
Date Posted: May 08, 2004 at 4:03 PM
Have you adjusted the jumpers for a higher setting?
Posted By: yelloboi1
Date Posted: May 08, 2004 at 4:13 PM
I'll try that when I get home from work later. However, will giving it that extra juice do anything to the driver side window, or can I adjust just the passenger side seperately? Thanks.
Posted By: brivalen
Date Posted: May 08, 2004 at 4:37 PM
you can adjust both independeltly
Posted By: auex
Date Posted: May 09, 2004 at 12:10 AM
Two things you can do. First make sure that you have a good clean ground, if you installed the window module inside the door then run your ground into the cab of the vehicle. Second you will probably have to adjust the resistance dipswitches.
-------------
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.
I've been sick lately, sorry I won't be on much.
Posted By: yelloboi1
Date Posted: May 26, 2004 at 1:49 PM
How would you adjust the dipswitches?
Posted By: ferio
Date Posted: May 26, 2004 at 7:59 PM
There is actually a update fix to increase the resistance even higher for higher load, but you have to open up the module and add resistors. I have seen it on the directech update sheet on the web. I would send you the diagram but I don't have access to the Directech.
Posted By: Teamrf
Date Posted: June 13, 2004 at 12:13 AM
Yea I'm having that same problem on my 2001 Honda Accord. The window doesn't roll up all the way and it is annoying to drive down the street with a little bit of air blowing into the window.
-------------
~The Rookie~
Rookie of the year that is...
Don't let the smoke out of your equiptment..it doesn't go back in.
Posted By: auex
Date Posted: June 13, 2004 at 1:50 AM
If you open the 530 up and all you see is microchips and not resistors then the problem is already been fixed.
-------------
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.
I've been sick lately, sorry I won't be on much.
|