2000 Plymouth Neon Door Trigger Problem

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=31868
Printed Date: November 07, 2025 at 2:39 PM

Topic: 2000 Plymouth Neon Door Trigger Problem

Posted By: gspin
Subject: 2000 Plymouth Neon Door Trigger Problem
Date Posted: May 09, 2004 at 7:25 PM

Hey All,
Could use a little help. I have a 2000 Plymouth Neon that I installed a Viper 650VX alarm system on. I followed every instruction to the T and used the reference here for the wiring diagram. Well, the good news is it installed almost perfect. The problem I have is... all the door triggers set the alarm off except the driver door (Which the (-) trigger wire is hooked to (Light Blue/Orange Strip). Not sure what to make of it. Any input would be great.

Thanks,
gspin

Replies:

Posted By: desh187
Date Posted: May 09, 2004 at 9:35 PM

I think it could be a defective driver door pin switch.Why dont you switch with the passenger one and see what happens.

Posted By: extreme1
Date Posted: May 10, 2004 at 11:44 AM

driver door pin is tan and passenger is blue/orange in each respective kick.

diode isolate and solder to the green wire.

-------------
Shaughn Murley
Install Manager, Dealer Services
Visions Electronics
Red Deer, Alberta

Print Page | Close Window