Clifford 3.5 install question

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=31869
Printed Date: November 07, 2025 at 9:56 AM

Topic: Clifford 3.5 install question

Posted By: Medievilknight
Subject: Clifford 3.5 install question
Date Posted: May 09, 2004 at 7:28 PM

I'm going to install this alarm into my 98 grand cherokee and was thinking of adding a couple of modules (like motion sensor, window roll up) , and i was wondering if i can install these modules through a switch...so i can turn them off. Sometimes i bring my dog around with me and would hate to come back to the car and see her head in the window, or have my alarm going off all the time...

Replies:

Posted By: draasch
Date Posted: May 09, 2004 at 9:49 PM

yes you should be able to add a switch on each setup....

-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt

Posted By: foskin007
Date Posted: May 12, 2004 at 2:57 PM

A Sugesstion is to break the interior sensor control wire usually the orange on the alarm module and fit a relay in between the break controled by one of the extra channel Channel 3 "Grep With Purple Stripe on wiring loom "Channel 3 " on the remote control Buttton 3 on 4 Channel remote or button 2 on its own on a 2 button remote control . You can then press channel 3 prior to arming the alarm as normal. Button 2 to click relay and then arm alarm as normal.

-------------
Jimbo

Print Page | Close Window