i need to instal a clifford concept 550 alarm in my nissan pulsar gti-r 1992 Import. the problam is i need the diagrams for my car i allready got the ones with the alarm but need the ones for my car can any one help me
p.s. i would be much appreciated as im looking for a very long time and was recomended this site
thanks a lot
omer
Alarm and Keyless Entry Wiring Colors and Notes |
Function | | Vehicle Color | Location |
Constant +12 Volts: | | WHITE | IGNITION SWITCH HARNESS |
Starter Kill: | | BLACK/ WHITE | IGNITION SWITCH HARNESS * |
Ignition +12 Volts: | | BLACK/ RED | IGNITION SWITCH HARNESS |
Dome Lights/Superv: | | RED / WHITE | (-) PASSENGER PIN SWITCH |
OEM Horn: | | GREEN / WHITE (-) | STEERING COLUMN HARNESS OR AT RELAY |
Power Lock: | | LIGHT GREEN/ BLACK | DRIVER DOOR AT SWITCH/CONTROL MOD. ** |
Power Unlock: | | SINGLE WIRE SYSTEM | DRIVER DOOR AT SWITCH/CONTROL MOD. ** |
Trunk Release: | | N/A | |
Alarm Input Wire: | | RED / WHITE | (-) PASSENGER PIN SWITCH |
Notes: | | ** See Note #206 - Single Wire Door Lock Diagram. |
Remote Starter Wiring Colors and Notes |
Function | | Vehicle Color | Location |
Start: | | BLACK/ WHITE | IGNITION SWITCH HARNESS * |
Ignition #1: | | BLACK/ RED | IGNITION SWITCH HARNESS |
Ignition #2: | | N/A | |
Ignition #3: | | N/A | |
Accessory: | | WHITE/ BLUE | IGNITION SWITCH HARNESS (HEAT-A/C) |
Brake Light: | | RED / GREEN (+) | SWITCH ON BRACKET ABOVE BRAKE PEDAL |
Tach Signal: | | BLUE/BLACK - DASH TACH | OR ENG CONTROL MOD OR GRN/YEL AT COIL |
Parking Lights: | | RED / BLUE | (+) AT LIGHT SWITCH |
Headlights: | | BLACK/ RED (DRIVER) (+) | RED / GREEN (PASS.) HIGH - AT LIGHT SW. |
OEM Alarm Disarm: | | N/A | |
OEM Alarm Arm: | | N/A | |
Diesel Glow Plug: | | | |
Clutch Bypass Wire: | | | |
Notes: | | * This Vehicle Is Equipped With Two Start Wires. Both Must Be Powered In Order For Vehicle To Start When Engine Is |
Hope this helps
-------------
MECP certified (If it really means anything)
Jeremy
hi the car which the diagram is for is not the one for me as the one im loking for is a gti-r 3 door 4wheel drive turbo
if u need more help with the car visit this site and it should help to identifi the car www.gtiroc.com
thanks
The wiring should be the same. pop the cover under the wheel and double check.
-------------
MECP certified (If it really means anything)
Jeremy
If not sorry i cant help you, are going to have to navigate your way thru with a volt meter.
-------------
MECP certified (If it really means anything)
Jeremy