clifford rs3/rsx3.5
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=32017
Printed Date: May 03, 2024 at 1:51 AM
Topic: clifford rs3/rsx3.5
Posted By: Javelin3o4
Subject: clifford rs3/rsx3.5
Date Posted: May 11, 2004 at 10:37 PM
I have a rs3 2 way alarm in one of my cars and a rsx3.5 in my other car, can i program one remote to work on both cars? if so how?
Replies:
Posted By: Bendog
Date Posted: May 12, 2004 at 12:40 AM
i actually did this in my brother car and my suv sam alarms too. i had and extra remote to my alarm that i gave to him because the old on on thr rs3 suck and i programed it using the steps in the install book of the alarm. but what sucks is that i use the same buttons for both cars so when i unlocked my car it unlocked his and when i open the trunk his trunk open too one big problem was remote start it started up both cars also the control goes biserk because it gets the both inputs from both alarms. if you have the install book that came with the alarm it tells you how to its not hard at all, if not try their website it should be there. i would suggest that you congifure different buttons for both cars so they dont intefere. use the buttons from the extra channels just hope you are not using extra channels.
Posted By: raydawg357
Date Posted: May 12, 2004 at 8:53 AM
It isn't recommended that you do this with the two way alarms. They were designed to be used with only one vehicle.
-------------
Do it right the first time
|