Print Page | Close Window

clifford solaris remote start help

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=32298
Printed Date: May 09, 2025 at 11:40 PM


Topic: clifford solaris remote start help

Posted By: sictruck
Subject: clifford solaris remote start help
Date Posted: May 17, 2004 at 6:43 PM

for the first time i tried wiring up my solaris in a 2001 s10 and everything seems to work correctly, except the remote start.  i put the truck in safestart mode and when i go to remote start it, nothing happens.  the fuel pump goes on and the accessories but no crank out of the starter.  here r some wires i didn't hookup:  heater relay,  interior light supply,  reverse light,  - pulse out before remote start,  and - pulse out after remote start.  could those wires cause this problem?

if so where should they connect,  if not what else is my problem? by the way it is a manual transmission




Replies:

Posted By: scirocco16v
Date Posted: May 18, 2004 at 12:36 AM
did you bypass the passlock system.  99% sure truck has it.  Usually it will still crank but it could be the problem. 




Posted By: sictruck
Date Posted: May 18, 2004 at 11:03 AM
what is the passlock system? 




Posted By: sictruck
Date Posted: May 20, 2004 at 12:44 AM
what wire do i hook up the passlock wire from the alarm?  is if for a second ignition wire?




Posted By: scirocco16v
Date Posted: May 22, 2004 at 1:17 AM
if when you turn the ignition on with the key and a light on the dashboard comes up as theft or security, you have passlock and you need a module to bypass it.  Dei 555l will work.  It sounds like you already have the white second ignition hooked up, which even if you didn't truck would probably still run, check engine would be on though.





Print Page | Close Window