Does anyone have the wiring codes for a 2000 kia sportage 4 door? All I really need is the lock and unlock wires and location. Also this car does not have a lock/unlock button it only works when you lift the tab on the top of the door this triggers all for doors to lock or unlock.
thanks
PS. what is the best way to hook up a back- up battery to an alarm?
YEAR: 2000 MAKE: Kia MODEL: Sportage STYLE: | ITEM | WIRE COLOR |POL | WIRE LOCATION |
| 12V |WHITE/ red | + |ignition harness *1 |
| STARTER |BLACK/ red | + |ignition harness *1 |
| IGNITION |BLACK / YELLOW | + |ignition harness *1 |
| SECOND IGNITION |BLACK/ white | + |ignition harness *1 |
| ACCESSORY |blue | + |ignition harness *1 |
| POWER LOCK |WHITE/ red *2 | - |drivers door harness |
| POWER UNLOCK |RED / green | - |drivers door harness |
| PARKING LIGHTS + |blue / YELLOW | |dash dimmer switch |
| PARKING LIGHTS - | | | |
| HEADLIGHTS | | | |
| DOOR TRIGGER |YELLOW /GREEN | - |drivers kick panel |
| DOME SUPERVISION |same as door trigger | | |
| TRUNK/HATCH PIN |GREEN/ YELLOW | - |at rear dome light |
| HOOD PIN | | | |
| FACTORY ALARM ARM |arms on lock | | |
|FACTORY ALARM DISARM |disarms on unlock | | |
| DISARM NO UNLOCK |lt. grn/blk or green | + |steering column *5 |
| TACHOMETER |yellow/white | |dianostic connector *3 |
| SPEED SENSE |blue/black | |ECM *4 |
| BRAKE WIRE |orange | + |brake pedal switch |
| HORN TRIGGER | | | |
| WIPERS | | | |
| LF WINDOW UP/DOWN | | | |
| RF WINDOW UP/DOWN | | | |
| LR WINDOW UP/DOWN | | | |
| RR WINDOW UP/DOWN | | | |NOTES:*1 If equipped with a knee air-bag system, unbolt without disconnecting toaccess wiring.*2 Can also find a blue/black wire in a yellow connector behind the dashdimmer switch or in the door boot and wire as type "F". This wire will not arm and disarm the factory alarm.*3 The dianostic connector is located in the rear of the enginecompartment on the drivers side.*4 ECM passenger floor 17 pin connector, 4 pole setting.*5 This is the key sense wire. The wire will meter 12v when the key isinserted in the ignition cylinder. Powering this wire as a third ignitionduring remote start will disarm the alarm without unlocking the doors. (c) 1994-2002 Directed Electronics, Inc. All Rights ReservedIMPORTANT: This wiring information is being provided free of charge on an "AS IS" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter. Directed Electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from an improper installation, even in reliance upon this information.