Print Page | Close Window

99 malibu,factory keyless entry,al 100 alarm

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=3246
Printed Date: May 05, 2025 at 12:52 AM


Topic: 99 malibu,factory keyless entry,al 100 alarm

Posted By: cem3
Subject: 99 malibu,factory keyless entry,al 100 alarm
Date Posted: September 01, 2002 at 3:25 PM

need help with installation of al 100 into existing factory keyless entry system. not finding the right places to make wire connections. has anyone done one of these before and are red and yellow made at key switch area or at fuse panel? removed under side of dash and didnt see easy access to wiring. i dont want to butcher anything and want to make a good clean installation. any help would be appreaciated.



Replies:

Posted By: Chris Luongo
Date Posted: September 01, 2002 at 11:01 PM

I'm having trouble understanding what you're trying to ask.

If you're trying to ask "How do I access the main ignition wires?", the answer is that you remove the radio and reach in that way. 

But I'm pretty sure that you can also find them in the main harness leading from the driver's underdash out into the engine compartment.  At least that's where I got them when I did a Grand Am, which is the same car as a Malibu. 

(Not that it matters to you, but the green second ignition wire wasn't available under the dash...but that's only needed if you're doing remote start.)


Print Page | Close Window