1st time install question

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=32477
Printed Date: July 22, 2025 at 4:57 AM

Topic: 1st time install question

Posted By: xoutlawz00x
Subject: 1st time install question
Date Posted: May 20, 2004 at 11:05 PM

Do i need to solder or use any thing specail like diodes to install an alarm or can i just make the connection and tape it real good to make sure it doesn't move

Replies:

Posted By: Velocity Motors
Date Posted: May 20, 2004 at 11:25 PM

Always use solder for your connections and depending on the vehicle, you may need relays, diodes and resistors. If this is for the 1997 Civic, then there is nothing special that is needed for the installation of the alarm system.

* Also, I didn't find any pics on my computer in regards to the actuator pictures for the Civic, sorry posted_image

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA

Posted By: profuse007
Date Posted: May 20, 2004 at 11:26 PM

what type of car?

the way that i make the connection is to slice the objective wire and split the strands in half, then stick the wire to it, then wrap the wire around it, and then tape it.

i have some pic of the actuator for 92-95 civic somewhere, i have to find it

-------------
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).

Posted By: xoutlawz00x
Date Posted: May 21, 2004 at 9:15 AM

thanks

Posted By: xoutlawz00x
Date Posted: May 22, 2004 at 9:46 PM

yea its for a 1997 civic hatchabck no factory alram

Print Page | Close Window