91 Olds Bravada rear window release

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=32574
Printed Date: July 12, 2025 at 5:35 PM

Topic: 91 Olds Bravada rear window release

Posted By: stony
Subject: 91 Olds Bravada rear window release
Date Posted: May 22, 2004 at 7:22 PM

I am trying to hook up a DEI 369 D to the rear window release of my 91 Olds Bravada. I found the diagram and instructions for wiring the relay on this site, but it isnt working for me. Anyone have an ideas? I found another link/diagram from a topic in this forum, which says to wire 12V+ to 85 and 30, while the diagram from this site says, 86 and 30.

Any help is appreciated.

Stony

Replies:

Posted By: draasch
Date Posted: May 22, 2004 at 11:11 PM

Trunk Release:
BROWN
(+) REAR WINDOW RELEASE SWITCH

86 12v
85 ground
30 to release wire above
87 to 12v

if the trunk release wire coming from the alarm is a neg. output, that wire will go to pin 85 as the ground wire.....

-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt

Posted By: stony
Date Posted: May 23, 2004 at 12:03 PM

Thanks, that did it, the solenoid pops slower than with the dash switch, but it works.

I just bought the truck during the winter, and the rear window does not open with the key. The only way to release it was to press the switch from inside.

Stony

Print Page | Close Window