Print Page | Close Window

DEI 6500esp factory disarm

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=32623
Printed Date: May 06, 2025 at 5:50 PM


Topic: DEI 6500esp factory disarm

Posted By: boosted-fc3s
Subject: DEI 6500esp factory disarm
Date Posted: May 23, 2004 at 8:50 PM

I have a customer with a 1988 mazda rx7 w/ the factory alarm.  He insists on keeping the factory alarm functional.  Is there an output on the 6500 that will pulse the factory disarm?  The brain says theres two, but one only pulses w/ remote start commands, and the other according to dei is status/factory rearm?  Thanks.




Replies:

Posted By: profuse007
Date Posted: May 23, 2004 at 9:30 PM
use the disarm wire to disarm when remote start. thats all you need, when you remotely unlock it should disarm, too.

-------------
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).



Posted By: boosted-fc3s
Date Posted: May 24, 2004 at 2:25 PM
Worked like a charm.  Thanks.



Posted By: Steve Michaluk
Date Posted: June 12, 2004 at 2:43 PM

I am trying to locate the factory alarm brain in my 1991 RX-7 convertible.

I am installing keyless entry, and have already installed actuator in

driver's door and run lead wires into car.  I would like to connect to

contant 12v, ground, alarm set, and alarm unset.  Can you please advice

which wire is constant 12v.

Thanks,

Steve 


Print Page | Close Window