2000 sonoma alarm/rem start

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=32633
Printed Date: May 08, 2025 at 3:03 AM

Topic: 2000 sonoma alarm/rem start

Posted By: 1badnotch
Subject: 2000 sonoma alarm/rem start
Date Posted: May 24, 2004 at 12:16 AM

i am in the process of installing a viper 800 esp alarm with a your valet 551t REMOTE STARTERin 2000 gmc sonoma and have a few questions here goes

1. do i need to wire the starter kill relay because my vehichlie is equiped with gm passlock 2

2. on the 551t it has secondary ignition what is this does it need to be hooked up

3. on the 551t relay pack the is a fuse holder what amp fuse goes in there

4. it says i need a dei 555l or 555t can i buy this at any stereo shop and where does it install on the alarm/ remote starter?

thanks in advance

ERIC

Replies:

Posted By: draasch
Date Posted: May 24, 2004 at 7:46 AM

1. its always good to have an extra one just in "case"...

2. it wouldnt hurt to power it up....

3.i dont use that unit...what is the relay pack for???

4. im not sure what the parts are for, but you should be able to get most DEI products at any shop...now how much will you pay for it....some shops charge an arm and a leg.....shop around first.....get all you parts together then do the install....if you dont and you really need the part, well you will pay top dollar....

-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt

Posted By: 1badnotch
Date Posted: May 24, 2004 at 12:05 PM

3.i dont use that unit...what is the relay pack for???

it is the external relays where all the heavy starter wires come from

Posted By: 1badnotch
Date Posted: May 26, 2004 at 12:55 AM

anyone else know about these units???

Posted By: 1badnotch
Date Posted: May 26, 2004 at 8:35 PM

ok heres another question

do i have to use the channel 3 output from the viper to activate remote start?

or can i use channel 4,5, or 6 as long as i use the sensor shunt input (BROWN / black) used to bypas sensors during remote start???