Injector (-) Wire ?

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=32931
Printed Date: May 19, 2025 at 3:12 AM

Topic: Injector (-) Wire ?

Posted By: radiantx
Subject: Injector (-) Wire ?
Date Posted: May 29, 2004 at 2:48 AM

I am installing a Peripherial NSS to allow remote start on a manual safely. It says "Connect this wire to the (-) wire of only one of the injectors."
This is not the same wire as the tachometer wire of the remote start, correct? I think that one is (+) AC.

Would it be easier to find it in the same bundle that I hooked the tachometer wire into at the coil pack instead of going to an injector?

Alan

Replies:

Posted By: Velocity Motors
Date Posted: May 29, 2004 at 10:20 AM

The injectors are (-) AC for remote starter's and it will be any of the uncommon colored ones that you want to tap into.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA

Posted By: radiantx
Date Posted: May 29, 2004 at 4:45 PM

So I can tap into the same wire that I used for the tachwire of the RS?

Posted By: Velocity Motors
Date Posted: May 30, 2004 at 12:27 AM

Yes you can, but there are 3 other's ( if it's a 4 cylinder ) that you can use. I suggest using a different one personally.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA

Print Page | Close Window