2001 dodge ram, viper 550 alarm/rs
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=32975
Printed Date: July 12, 2025 at 8:21 AM
Topic: 2001 dodge ram, viper 550 alarm/rs
Posted By: jrrose76
Subject: 2001 dodge ram, viper 550 alarm/rs
Date Posted: May 30, 2004 at 11:43 AM
know how i can get a diagram to in this on a 2001 dodge ram sport 4x4 off road? thnx in advance
Replies:
Posted By: auex
Date Posted: May 30, 2004 at 11:46 AM
It should be the same as this.------------- Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.
I've been sick lately, sorry I won't be on much.
Posted By: jrrose76
Date Posted: May 30, 2004 at 11:50 AM
i work on electronics on aircraft so i'm familiar with the area just not on trucks how hard is it to locate were these wire actually are? and when i find the locations, will i ver run into finding the same color wire on multiple wires? thnx
Posted By: auex
Date Posted: May 30, 2004 at 11:56 AM
If you have a meter then you are set. For most of the install you only need to go three places for wires, the ignition harness, light switch, and driver's kickpanel. The hardest wire to test for an find is going to be the tach wire, still easy though, it is BLACK/ grey at the computer or ign coil. Overall a pretty simple install for most people, as long as you have a basic working knowledge of your tools and how to use them.
-------------
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.
I've been sick lately, sorry I won't be on much.
Posted By: jrrose76
Date Posted: May 30, 2004 at 11:58 AM
thank you very much were is the computer. if only this was an aircraft i'd be ok thnx
Posted By: jrrose76
Date Posted: May 30, 2004 at 12:03 PM
another question i had is i dont have one right now but i was told i can add a function to this alarm so that when me alerm is activated is will roll up the windows. how easy would that be to install down the road? and if me windows are already rolled up and it reconize that, or keep trying to roll them up for a predetermined amount of time? thanx
Posted By: auex
Date Posted: May 30, 2004 at 12:04 PM
Location's of the wires are listed in the far right column of the link that I posted. At any rate,
"Tach BLACK/ Gray PCM Passenger's Rear of Engine on Firewall "
-------------
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.
I've been sick lately, sorry I won't be on much.
Posted By: auex
Date Posted: May 30, 2004 at 12:05 PM
Window mods can be added at any time. What the window mod will do is roll the windows up when you arm the alarm. If the window is already up then it does nothing.
-------------
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.
I've been sick lately, sorry I won't be on much.
Posted By: jrrose76
Date Posted: May 30, 2004 at 12:09 PM
thnx i'm off to work on this truck is already ripped apart from a stereo install should be good to go i'm guessing pcm means computer its on the firewall, but is the under the hood or in the cab? thnx for all the help
Posted By: auex
Date Posted: May 30, 2004 at 1:41 PM
Hood.
-------------
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.
I've been sick lately, sorry I won't be on much.
|