Yukon remote start question

I have a 96 yukon that I put an alarm w/RS on but the RS won't work.  Everything is connected minus the hood switch and negative safety switch.  It is a viper 560xv.  I can start it with the key no problem, and the alarm works fine.  If I ground out the starter trigger on the remote start ribbon it cranks up.  When I try to use the remote it does nothing.  I don't hear the relay click either.  Any ideas?

-------------
"I'm Rick James bi***, enjoy yo' self Ah Ah Ah"
Dave Chappelle as Rick James

Have you grounded the BLACK/ white nuetral safety switch wire, must be grounded to be able to remote start the truck? Does your truck have an immobilizer? Why are you messing with the ribbon cable, don't do this?

-------------
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.

I've been sick lately, sorry I won't be on much.

Grounded the neutral safety and tried the remote start, didn't work.  Is the tach wire a necessity?  I understood that it will check voltage if the tach wire is not connected, but don't exactly know as I am a newb.  I only grounded the starter trigger to see if it would start (got the idea from willTS).   I also reconnected it as soon as I was done testing it.  Wouldn't that mean that it is connected right?  I mean that the starter should start as far as the relay is concerned.  I was told it doesn't have an immobilizer, but once again not completely sure.(man I sound dumb!)  It has keyless entry but that's all I'm sure of.

-------------
"I'm Rick James bi***, enjoy yo' self Ah Ah Ah"
Dave Chappelle as Rick James

Does it crank and die or not crank at all? Do you hear any clicking at all when you try to remote start it? Try this, ground the WHITE/ blue wire for one second and see if it remote starts. It will not go to voltage check if you don't connect the wire, you have to change this in the programming.

-------------
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.

I've been sick lately, sorry I won't be on much.

I didn't ground it until it started completely, it cranked but I never let it start completely.  Don't know why i did that, but I've been fighting this thing for a week and a half.  I tried grounding the blu/wht wire twice to mimic two - pulses, but I'll try grounding it for a full sec.  Now that you mention the programming thing, I saw that in the manual (duh!)  Also, no clicking when I press the remote start button at all.  I'll post as soon as I try the blu/wht wire and try to program to check voltage.

-------------
"I'm Rick James bi***, enjoy yo' self Ah Ah Ah"
Dave Chappelle as Rick James

Tried the blu/wht and nothing.  I also set the programming to check voltage.  All did zero, no clicking either.  I couldn't try to ground the starter trigger again, won't be able to until tomorrow.

-------------
"I'm Rick James bi***, enjoy yo' self Ah Ah Ah"
Dave Chappelle as Rick James

Have you got the tach wire hook up? If not doing the tach have you program it for non-tach?
Have the alarm LEARNED THE TACH?
Have you change ANY of the programing?
Got all the ING and ACC wire hook up?

No tach wire, but no change to the programming either.  All the wires ingnition wires from the RS relay are hooked up.  If I take the RS trigger and ground it, it cranks over.  It just won't with the remote.

-------------
"I'm Rick James bi***, enjoy yo' self Ah Ah Ah"
Dave Chappelle as Rick James

looking at the omega wire disk in the remote start part for
your car has this listed "netral safty / not gounding type / oem switch open starter circit. never heard of that.

Here the wire guide from it

Make:
Model:
Year:
GMC
Yukon
1996
Alarm
Function Color Location
Constant 12 volts RED (2) IGNITION SWITCH HARNESS
Ignition 12 volts PINK IGNITION SWITCH HARNESS
Starter YELLOW IGNITION SWITCH HARNESS
Dome Light PURPLE (-) 4 PIN BLACK CONN. IN DR. KICK PANEL *
Trunk Pin Switch PURPLE (-) SAME CIRCUIT AS ABOVE
Parking Lamp BROWN (+) AT HEADLIGHT SWITCH
Power Lock L BLUE DRIVER KICK ** #203
Power Unlock WHITE PANEL #202
* PURPLE (-) Wire Also Located At Headlight Switch. See Tech Notes For Additional Information On Dome Light. ** 2 Door Without OEM Keyless
Entry See Note #203. 2 Door With OEM Keyless Entry See Note #202. 4 Door With Or Without OEM Keyless See Note #202. #203- See Reversal
Rest At Ground Door Lock Diagram. #202- See Positive Pulse Door Lock Diagram.
Accessories
Function Color Location
Window Up D\ D BLUE P\ L BLUE D\ D GREEN P\ L GREEN @ MAIN #211
Window Down F/ BROWN F/ TAN R/ PURPLE R/ PURPLE SWITCH
Ign Key Warn L GREEN (-) IGNITION SWITCH HARNESS
Trunk Release N/A
OEM Horn BLACK (-) STEERING COLUMN HARNESS
Headlights YELLOW (+) AT HEADLIGHT SWITCH
OEM Alarm Arm N/A NO OEM ALARM PRESENT
OEM Alarm Disarm N/A IN SCHEMATICS
#211- See Reversal Rest At Ground Power Window Circuit Diagram.
Remote Start
Function Color Location
Tach Signal WHITE AT COIL ON PASSENGER REAR OF ENGINE
Ignition #2 WHITE IGNITION SWITCH HARNESS *
Ignition #3 ORANGE IGNITION SWITCH HARNESS #216,#235
Accessory BROWN IGNITION SWITCH HARNESS
Neutral Safety NOT GROUNDING TYPE - OEM SWITCH OPENS STARTER CIRCUIT
Brake Light WHITE (+) AT SWITCH ABOVE BRAKE PEDAL
Reverse Light L GREEN (+) AT CONVENIENCE CENTER MODULE **
Rear Window Defrost N/A TIMER BUILT INTO SWITCH
* Wire Has Also Been Found As PINK/WHITE-No WHITE Wire Present ** Convenience Center Module Located Behind Left Side Of Driver Dash.
#216- See G.M. Extra Ignition Diagram. #235- See Powering Extra Ignitions Diagram
InterConnect Harness
Function Part # Available Location
StrInt,+12,Gnd,Ign 2220 yes LARGE BLACK CONN. AT BASE OF COLUMN
Horn Honk 2220 yes LARGE BLACK CONN. AT BASE OF COLUMN
Lock & Unlock 2223 * yes IN ACCESS HOLE BEHIND DR. KICK PANEL
Light Flash no
Dome Light no
Trunk Switch no
AL-100 / VIP-4000 no
Remote Start 2229 yes LARGE BLACK CONN. AT BASE OF COLUMN
* 2223 Is For Two Door Vehicle Without Factory Keyless Entry, For Vehicles With Factory Keyless Entry Or Four Door Vehicles Use A 2225
Harness. 2225 Located In Access Hole Behind Driver Side Kick Panel.

But on the Techsoft that is not listed but does have a disarm defeat. passanger door boot a tan wire, that "color" is the same as the unlock motor. not sure if its the same.

since you have not went into program mode do that and go to remote start part and then to tach part set it to "volatge"

Also how is the "activaction pulse count" do u have it set for.