how to get doors to pop open with alarm

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=33318
Printed Date: May 29, 2024 at 3:22 AM

Topic: how to get doors to pop open with alarm

Posted By: 02SS
Subject: how to get doors to pop open with alarm
Date Posted: June 04, 2004 at 7:23 PM

What is the best way to activate shaved door solenoids with a clifford alarm? I am needing a diagram of how to accomplish this.

Replies:

Posted By: profuse007
Date Posted: June 04, 2004 at 7:48 PM

youll need an auxilary channel to control the solenoid. the channel usually pulse a negative trigger thats enough for a bosch type relay.

set up the relay this way:
85-aux channel input
86-12volt constant fused
30-12volt constant fused
87-to the (+) of the solenoid and the other wire of the solenoid to ground.

-------------
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).

Posted By: auex
Date Posted: June 04, 2004 at 7:50 PM

Or you could use the same relay diagram but tie it into the unlock output of your alarm for the driver's door and the same diagram and wired to your progressive unlock output of the alarm for a second door.

-------------
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.

I've been sick lately, sorry I won't be on much.

Posted By: profuse007
Date Posted: June 04, 2004 at 7:54 PM

auex] wrote:

Or you could use the same relay diagram but tie it into the unlock output of your alarm for the driver's door and the same diagram and wired to your progressive unlock output of the alarm for a second door.

there ya go!!
thanks auex

-------------
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).

Print Page | Close Window