I recently installed a Valet 554r on my wife 1997 Lexus ES 300 Every thing seems to be working ok but after it autostarts the Radio and heating/AC display flash from a dim to a bright. However if I un-hook the parking light flash it dose not do it.
I used the white wire in the primary harness switched to Positive [ + ] and tied it into a GREEN/ orange wire that comes off the bottom of the fuse block facing you as you look at it. Dose anybody know am I tied into the wrong wire or do I need a negative pulse on a different wire? Or maybe a relay ? I am at a loss, but I do know something is not hooked up right but I have no information to bale me out…
Thanks for your help guys
-------------
If it too fast your Too old...
According to the diagram I see its a positive system and the wire your looking for is green.
Remote Starter Wiring Colors and Notes |
Function | | Vehicle Color | Location |
Start: | | BLACK/ WHITE | IGNITION SWITCH HARNESS |
Ignition #1: | | BLACK/ ORANGE | IGNITION SWITCH HARNESS |
Ignition #2: | | BLACK / YELLOW | IGNITION SWITCH HARNESS |
Ignition #3: | | N/A | |
Accessory: | | PINK/BLUE | IGNITION SWITCH HARNESS |
Brake Light: | | GREEN / WHITE (+) | AT SWITCH ABOVE BRAKE PEDAL |
Tach Signal: | | BLACK | AT ENGINE CONTROL MODULE * |
Parking Lights: | | GREEN (+) | # PIN CONNECTOR AT FUSE BLOCK |
Headlights: | | RED / YELLOW (-) | AT HEADLIGHT SWITCH |
OEM Alarm Disarm: | | RED / BLUE (-) | IN DRIVER KICK PANEL |
OEM Alarm Arm: | | YELLOW/RED (-) | # PIN CONNECTOR |
Diesel Glow Plug: | | | |
Clutch Bypass Wire: | | | |
Notes: | | * Engine Control Module Located Behind Glove Box. BLACK Tach Wire Also Found In 10 Pin Connector At Fuse Block In Driver Kick Panel. |
Alarm and Keyless Entry Wiring Colors and Notes |
Function | | Vehicle Color | Location |
Constant +12 Volts: | | WHITE/ RED & WHITE | IGNITION SWITCH HARNESS |
Starter Kill: | | BLACK/ WHITE | IGNITION SWITCH HARNESS |
Ignition +12 Volts: | | BLACK/ ORANGE | IGNITION SWITCH HARNESS |
Dome Lights/Superv: | | GREEN/ RED (-) | 6 PIN CONNECTOR AT FUSE BLOCK ** |
OEM Horn: | | GREEN/ BLACK (-) | STEERING COLUMN HARNESS |
Power Lock: | | PINK/BLACK | # PIN BLUE CONN. IN DR. KICK *** |
Power Unlock: | | GREEN | I# PIN BLUE CONN. IN DR. KICK *** |
Trunk Release: | | BLUE (+) | # PIN CONN. IN DR. KICK PANEL **** |
Alarm Input Wire: | | GREEN/ RED (-) | 6 PIN CONNECTOR AT FUSE BLOCK ** |
Notes: | | ** Fuse Block Located In Driver Kick Panel. RED / WHITE (-) At This Same Location Can Also Be Used. *** See Note #209 - Toyota Door Lock Diagram. **** See Note #232 Positive Pulse Door Lock Diagram. |