installing immobiliser in 94 ford transit

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=33604
Printed Date: May 02, 2025 at 6:22 AM

Topic: installing immobiliser in 94 ford transit

Posted By: transitman
Subject: installing immobiliser in 94 ford transit
Date Posted: June 09, 2004 at 11:37 PM

can anyone help?

"2nd isolating circuit (18A relay used for this circuit). This circuit must
be live during cranking and engine running."

what wire can i use for this connector and where to find it?

cheers

Replies:

Posted By: draasch
Date Posted: June 10, 2004 at 8:57 AM

not sure i follow you. are you installing a starter disable????

if so, use a meter to find the starter wire (will show 12v when the key is cranking the motor)

take and cut the wire in two.

wire a relay as follows:
86 12v
30 key side of starter wire
87a other side of starter wire
85 neg output from alarm when armed.

-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt

Posted By: jfk51502003
Date Posted: June 10, 2004 at 10:33 AM

"2nd isolating circuit (18A relay used for this circuit). This circuit must
be live during cranking and engine running."...it sounds like you need to get ignition wire ...power when on and cranking...right...?

Posted By: transitman
Date Posted: June 10, 2004 at 3:27 PM

sorted now use the wire that goes to the cold start solonoide

thanke for the help

Posted By: transitman
Date Posted: June 10, 2004 at 3:28 PM

sorted now use the wire that goes to the cold start solonoide

thanks for the help

Print Page | Close Window