Print Page | Close Window

Alpine 8040 Alarm System Programming

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=33618
Printed Date: May 08, 2025 at 12:29 AM


Topic: Alpine 8040 Alarm System Programming

Posted By: ruvtvetguy
Subject: Alpine 8040 Alarm System Programming
Date Posted: June 10, 2004 at 6:25 AM

Hello I need to know how to program my alpine alarm, I have everything but the manuel. I'm not sure what to do as far as the programming of a new remote, thanks.

Ryan



Replies:

Posted By: larrydittman
Date Posted: June 10, 2004 at 8:17 AM
Ryan,
Inside the new remote is a rom chip. The rom chip must be removed from the remote and put into the alarm main brain and the ignition switch is to be turrned to the accessory position. Take the valet switch and turn it on with the key still in the accessory position. Turn the car off and then start car and take the rom chip back out and out it back into your remote. Turn the valet switch off and then the key right after. Get out of car and try your remote. Hope that helps you. Any further questions see your local shop.

Larry


Print Page | Close Window