Print Page | Close Window

door locks on ungo sr5000

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=33648
Printed Date: May 15, 2025 at 1:52 AM


Topic: door locks on ungo sr5000

Posted By: bondskier
Subject: door locks on ungo sr5000
Date Posted: June 10, 2004 at 5:14 PM

i am seriously considering purchasing an ungo sr5000, but i am wondering about the wiring for the locks. My '87 porsche 944 has manual locks, and i am wondering what kind of relay wiring i should use for this alarm. I am 16 and i am most definitely competent enough to install it, but the alarm has 2 wires that switch outputs from - to + depending on if it is locking or unlocking (i. e. lock a="+"b="-", unlock a="-" b="+")
is this a situation where i use a 3 wire relay setup? i know that i need to use relays, because the installation manual for the alarm says that and little else install. manual (go to page 18) thanks



Replies:

Posted By: jfk51502003
Date Posted: June 10, 2004 at 5:20 PM
you have actuators also right...?



Posted By: bondskier
Date Posted: June 10, 2004 at 9:00 PM
i am going to get them, and most of the ones i see are 2 wire, is that the best choice? i am trying to keep the system as cheap as possible without sacrificing too much


Print Page | Close Window