Compustar CM3000, Status Output, ’00 Jeep

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=33658
Printed Date: May 15, 2025 at 3:20 PM

Topic: Compustar CM3000, Status Output, ’00 Jeep

Posted By: hbay785
Subject: Compustar CM3000, Status Output, ’00 Jeep
Date Posted: June 10, 2004 at 7:01 PM

I installed a CM3000 2wfm-as alarm system on a '00 jeep cher and do not know where to connect the status output wire. Also how do you get the remote pager to work with the alarm does it have to be programed or could the antenna be bad

-------------
Tye

Replies:

Posted By: draasch
Date Posted: June 11, 2004 at 7:24 AM

what does the install manual say about that wire??

-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt

Posted By: hbay785
Date Posted: June 11, 2004 at 7:35 AM

The manual says " (-) Status output CN2 this comes in one second before ignition on and continues until one second after ignition off."

I was guessing it has to do with bypassing a imoblizer but im not sure

-------------
Tye

Posted By: deviousjoker
Date Posted: June 11, 2004 at 2:19 PM

if you don't have the grey key on your jeep then don't worry about it.

-------------
First Class MECP Installer

Posted By: hbay785
Date Posted: June 11, 2004 at 5:44 PM

so the status output wire is for sure used for bypassing the imobilizer?

-------------
Tye

Print Page | Close Window