01 intrepid keyless entry

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=33747
Printed Date: July 27, 2025 at 11:04 PM

Topic: 01 intrepid keyless entry

Posted By: dereka81
Subject: 01 intrepid keyless entry
Date Posted: June 12, 2004 at 3:14 PM

can anyone give me the wiring diagram for a simple keyless entry? All lock, all unlock, and parking light illumination only. I am stuck with trying to figure out these three wires and the ignition wire hookup. Thanks alot to anyone who can help.

Replies:

Posted By: draasch
Date Posted: June 12, 2004 at 4:12 PM

Make: Dodge
Model: Intrepid
Year: 2001
Alarm
Constant 12 volts RED & PINK/BLACK IGNITION SWITCH HARNESS
Ignition 12 volts D BLUE/WHITE IGNITION SWITCH HARNESS
Starter YELLOW IGNITION SWITCH HARNESS
Dome Light YELLOW (-) AT EITHER KICK PANEL OR BCM *
Trunk Pin Switch TAN/BLACK (-) 22 PIN CONNECTOR HIGH IN DRIVER KICK
Parking Lamp BLACK / YELLOW (+) AT BODY CONTROL MODULE *
Power Lock WHITE/ D GREEN 16 PIN CONN. IN ACCESS HOLE #217**
Power Unlock SINGLE WIRE SYSTEM IN DRIVER KICK OR HIGH IN DR. KICK

* Body Control Module (BCM) Located Behind Fuse Box. #217- See Single Wire Resistor Door Lock System Diagram. **Door Locks Require +12v Pulse Thru 2.7K Ohm Resistor For Lock And +12V Pulse Thru 620 Ohm Resistor For Unlock.

-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt

Posted By: dereka81
Date Posted: June 12, 2004 at 7:23 PM

Ok, so I got the park lamps flashing when a lock/unlock signal is sent through the controller, but cannot get the locks to work. If I am reading the single wire lock system diagram right, both the lock and unlock outputs connect to the same wire. I have found the wire to hook the outputs to, but nothing happens. Also, do I really need to hook up the ignition wire? Again, this is nothing more than a simple keyless entry turning into a not so simple job. Thanks for all the help, I wouldn't be as far as I am without it.

Posted By: dereka81
Date Posted: June 12, 2004 at 7:27 PM

Also, do I need a resistor on the unlock circuit?

Posted By: draasch
Date Posted: June 12, 2004 at 8:01 PM

yes here are the values that you will need.

you can be with 5% of each....

**Door Locks Require +12v Pulse Thru 2.7K Ohm Resistor For Lock And +12V Pulse Thru 620 Ohm Resistor For Unlock

-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt