Hi all.
This is my first post here so I hope I don't come accross as foolish.
I am a sort of hands on... can do anything type of guy, but I do struggle with electrical stuff sometimes.
I am presently fitting a asian car alarm to my Mitsubishi Pajero diesel. The instructions are probably the worst anyone could imagine.
I got the alarm off ebay, and as such, the alarm is a no name type from China.
Can anyone tell me how to wire up an ignition relay to suit a diesel? The schematic provided shows the relay is to be setup for a petrol vehicle with a coil etc. I have run my meter over the ignition and think I am ok with identifying conections there. So where does this relay wire go, that is supposed to hook up to coil?
I have read through and searched a lot of this site...... The question I have asked may be too basic I think.
Any help very much appreciated.
Fossil 
I am not sure but I think what your are looking for is a tach wire to tell the alarm when the vehicle is running, this is only if you are installing a remote start. Find a tach wire, being a diesel it should have one. You didn't post the year, or I didn't see it, but for a 99 the tach wire is WHITE/ blue behind the instrument cluster/tachometer. Post some more info on what exactly you are doing.
-------------
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.
I've been sick lately, sorry I won't be on much.
hello i wonder if you could help i have amitsubishi pajero on a J plate i am fitting a alarm with engine start but my pajero is diesel one of the wires should be fitted to the coil could you help
-------------
actionman