Im a amature when it comes to installing my first alarm and im reading about cars with positive door trigger and negative door trigger how can someone tell whether its positive or negative triggers?? Because I need to find out because im about to install my first alarm
If it helps I have a mitsubishi galant 94
Make: Mitsubishi
Model: Galant
Year: 1994-96
Alarm
Constant 12 volts RED IGNITION SWITCH HARNESS
Ignition 12 volts BLACK/ WHITE IGNITION SWITCH HARNESS
Starter BLACK / YELLOW IGNITION SWITCH HARNESS
Dome Light GREEN/ ORANGE / SILVER::: DRV KICK PAN.OR GRN/RED AT ANY PIN SW
Trunk Pin Switch GREEN/ BLACK (-) AT LGT OR BROWN / BLUE (-) AT SWITCH IN LATCH
Parking Lamp GREEN / WHITE (+) FUSE/JUNCTION BOX IN DR. KICK PANEL *
Power Lock GREEN / WHITE BEHIND JUNCTION BLOCK TO #201
Power Unlock RED / GREEN LEFT OF STEERING COLUMN
* Remove Two 10MM Bolts To Drop The White Junction Block. Door Lock Wires Found Behind Harness. #201- See Negative Pulse Door Lock Diagram.
Remote Start
Tach Signal BLACK / YELLOW AT DISTRIBUTOR *
Ignition #2 BLUE/BLACK IGNITION SWITCH HARNESS
Ignition #3 N/A
Accessory BLUE/WHITE IGNITION SWITCH HARNESS
Neutral Safety NOT GROUNDING TYPE - OEM SWITCH OPENS STARTER CIRCUIT
Brake Light GREEN (+) AT SWITCH ON BRAKE PEDAL BRACKET
Reverse Light RED / BLUE (+) AT GEAR SELECT SWITCH
Rear Window Defrost N/A
* Single Overhead Cam (SOHC) Engine At 2 Pin Connector, Dual Overhead Cam (DOHC) At End Of 8 Pin Connector. Dual Overhead Cam Also Has Single Pin Test Connector Taped To Harness On Firewall.
-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt