2005 colarado, alarm/remote start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=33963
Printed Date: May 21, 2024 at 10:28 AM
Topic: 2005 colarado, alarm/remote start
Posted By: tek1000
Subject: 2005 colarado, alarm/remote start
Date Posted: June 15, 2004 at 9:14 PM
any have wire diagram for alarm an remote start for a 2005 chevy colarado.
Replies:
Posted By: jfk51502003
Date Posted: June 16, 2004 at 11:33 AM
DIRECTWIRE™ WIRING INFORMATION - CHEVROLET / COLORADO / 2004 / Remote Start[PRINT THIS PAGE]
12volts | WHITE/ black to orange (10A) | + | ignition harness | Starter | see notes | | | Notes: There is a white (to WHITE/ blue) wire and a WHITE/ black (to WHITE/ yellow) wire at the ignition harness that performs the following: key sense, second ignition, starter, and Passlock resistance. Call Directed technical service for more information. | Second Starter | N/A | | | Ignition | WHITE/ green to dk. blue | + | ign harn or BCM, gray plug, pin B8 | Notes: The BCM (Body Control Module) is in the passenger kick panel. | Second Ignition | see starter wire notes | | | Third Ignition | N/A | | | Accessory | WHITE/ red to brown | + | ign harn or BCM, gray plug, pin B7 | Notes: The BCM (Body Control Module) is in the passenger kick panel. | Second Accessory | N/A | | | Keysense | see starter wire notes | | | Power Lock | lt. blue | - | either kick or BCM, blk plg, pin A11 | Notes: The BCM (Body Control Module) is in the passenger kick panel. | Power Unlock | dk. blue | - | either kick, door harness | Notes: To unlock just the driver door use white (-) at the BCM, black plug, pin A12.
The BCM (Body Control Module) is in the passenger kick panel. | Lock Motor | gray | 5wi | lock switch in driver door | Unlock Motor | tan | 5wi | lock switch in driver door | Parking Lights+ | brown | + | BCM, black plug, pin A48 | Notes: The BCM (Body Control Module) is in the passenger kick panel. | Parking Lights- | BROWN / white | - | switch or BCM, gray plug, pin A7 | Notes: The BCM (Body Control Module) is in the passenger kick panel. | Hazards | white | - | switch or BCM, gray plug, pin A48 | Notes: The BCM (Body Control Module) is in the passenger kick panel. | Turn Signal(L) | lt. blue (F), yellow (R) | + | BCM, black plug, pins A3, B1 | Notes: The BCM (Body Control Module) is in the passenger kick panel. | Turn Signal(R) | dk. blue (F), dk. green (R) | + | BCM, black plug, pins A19, B2 | Notes: The BCM (Body Control Module) is in the passenger kick panel. | Reverse Light | lt. green | + | inside mirror or fuse box under hood | Door Trigger | see notes | - | BCM, black plug | Notes: The driver door trigger is gray/black in pin A32, the passenger door is lt. GREEN/ black in pin A38, the left rear door is lt. blue/black in pin A44, and the right rear door is BLACK/ white in pin A39. Use all four and diode isolate each.
The BCM (Body Control Module) is in the passenger kick panel. | Dome Supervision | white | - | BCM, black plug, pin A46 | Notes: The BCM (Body Control Module) is in the passenger kick panel. | Trunk/Hatch Pin | N/A | | | Hood Pin | N/A | | | Trunk/Hatch Release | N/A | | | Power Sliding Door | N/A | | | Factory Alarm Arm | | | | Factory Alarm Disarm | | | | Disarm No Unlock | | | | Tachometer | NOT pink or black | ac | any ignition coil or injector | Wait to start | N/A | | | Brake Wire | lt. blue | + | brake pedal switch | Parking Brake | lt. blue | - | switch or BCM, black plug, pin A31 | Notes: The BCM (Body Control Module) is in the passenger kick panel. | Horn Trigger | green to black | - | column or BCM, gray plug, pin A25 | Notes: The BCM (Body Control Module) is in the passenger kick panel. | Memory Seat 1 | N/A | | | Memory Seat 2 | N/A | | | Memory Seat 3 | N/A | | | < Immobilizer Bypass Module: | Required: Yes | Type: Passlock | Part #: N/A | Notes: Call Directed technical service for interface information. |
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter. Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information. |
|
Posted By: johnmax
Date Posted: June 16, 2004 at 5:29 PM
Anyone have that starter/transponder info that you need to call DEI tech for?
|