Matrix 3.5 questions

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=34052
Printed Date: May 16, 2024 at 3:13 AM

Topic: Matrix 3.5 questions

Posted By: chaley16
Subject: Matrix 3.5 questions
Date Posted: June 17, 2004 at 8:14 AM

I tried to splice my factory security LED to the 3.5 LED and the clifford works but the factory light doesnt. Can you only run one LED off the Clifford? Also I was reading that it is possible to change the alarm sound, how is it done? Thanks

Replies:

Posted By: sroth140
Date Posted: June 17, 2004 at 11:39 AM

you can run more that one LED, but i think its best to use all aftermarket ones.

as far as the siren sounds, you cant really "change" them, but you can eliminate ones. dissamble the siren and pull it open. there will be 6 metal tracers labeled one to six. simply cut a loop to delete that sound. the siren will still sound the full amount of time, it will play the remaining sounds and repeat for the full duration.

-------------
MECP certified installer

Posted By: Teamrf
Date Posted: June 17, 2004 at 7:07 PM

You can run any LED just make sure you have the correct voltage on that LED. Some are 2 and some are 4. So just check and make sure you have the right voltage, and use a resistor accordingly.

-------------
~The Rookie~
Rookie of the year that is...
Don't let the smoke out of your equiptment..it doesn't go back in.

Print Page | Close Window