Window module in 95 eclipse

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=34143
Printed Date: May 23, 2024 at 11:33 AM

Topic: Window module in 95 eclipse

Posted By: anumeric
Subject: Window module in 95 eclipse
Date Posted: June 18, 2004 at 9:41 PM

I'm having problems getting my window module to work. It's a stingpro pw-200 I purchased off of ebay. I'm trying to get the module to roll up the windows when arming it. The 12 volt source I am using is from the ignition (not sure if that's what i should be using or not), i've connected the driver's UP window switch and motor to the respective wires, grounded the module. The part where I think I F-ed up is the starter kill relay. I wired the solid yellow to the alarm brain and the yellow/white to the kill switch...is that right?

Replies:

Posted By: ka3vvv
Date Posted: June 24, 2004 at 4:19 AM

if you would like window to go up you need to cont to the orange if that the one that put out the ground with arm from your alam wich my go the the startkill.

with some window module the yellow wire is the up wire.

do a test with your window moudule ok you have a yellow wire and a yellow/white. one of those wire make the window go up in one make it go down. take one of those wire in put it to ground on the body of the car in see what happen. the window wil go up or down.

you may have a black wire/white if your use your module to roll win up or down. this lop need to be cut. this with most window moudule.

check out paper work that come with your module,

Posted By: anumeric
Date Posted: June 24, 2004 at 12:16 PM

i think you've got my module confused...it's setup to either roll up or roll down...you can only make it go up and down if you had 2 modules...