507T tilt sensor falsing

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=34356
Printed Date: July 09, 2025 at 7:31 PM

Topic: 507T tilt sensor falsing

Posted By: dhs-9
Subject: 507T tilt sensor falsing
Date Posted: June 22, 2004 at 9:22 AM

I have a 507T motion/tilt sensor which is wired to the clifford matrix ground when armed wire. the motion sensor is set for 3 degrees tilt , normal motion, 2 min delay. After being armed for 6-10 min it falses. Also I have the trigger on hte trunk but whenit falses the hood icon flashes also. I dont even have anything hooked up to the hood. Anyone know why it falses and the hood icon appears.

Thanks

Replies:

Posted By: draasch
Date Posted: June 22, 2004 at 11:47 AM

on most units the hood can also be the trunk wire.....are you using the - trigger wire??? not the one for the door....

if so sis you diode isolate each item???
if not try that....

-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt

Posted By: promodeepcycle
Date Posted: June 22, 2004 at 2:10 PM

are you using the instant trigger or multi-plex?

-------------
dont be a pet monkey ..use your dmm

Posted By: dhs-9
Date Posted: June 22, 2004 at 2:23 PM

I am using the instant trigger I had the trunk trigger unused so I used that trigger for the tilt sensor.

Thanks

Print Page | Close Window