2003 silverado remote start, keyless entry
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=34362
Printed Date: May 15, 2024 at 2:12 PM
Topic: 2003 silverado remote start, keyless entry
Posted By: chicomax75235
Subject: 2003 silverado remote start, keyless entry
Date Posted: June 22, 2004 at 11:47 AM
just wondering where do i connect the blue wire from the 557l module,also cant find the bcm,beneath the stering colum i can see one but it has only five plugs and on the wiring diagram it says it has six,also on the 456g where does the data bus output connect too also input from remote start ------------- Jose Chapa
Replies:
Posted By: draasch
Date Posted: June 22, 2004 at 11:50 AM
Make: Chevrolet
Model: Pickup - Fullsize
Year: 2003
Alarm
Constant 12 volts RED (2) IGNITION SWITCH HARNESS
Ignition 12 volts PINK IGNITION SWITCH HARNESS
Starter YELLOW IGNITION SWITCH HARNESS
Dome Light DR (-) GY/BK PAS (-) BLK/WHT IN EACH DOOR(BASE MODEL BCM)
Trunk Pin Switch
Parking Lamp GRAY/BLACK (-) HEADLIGHT SWITCH *
Power Lock GRAY SEE TECH NOTES (BASE MODEL #201
Power Unlock TAN FOR DOOR LOCK INFO **
#201- See Nevitive Pulse Door Lock Diagram (Base Model).Lock L BLUE, Unlock WHITE Both Found At the B.C.M. Located Under Drivers Dash. * Parking Light Wire Has Also Been Found As A BROWN / WHITE (+) High In Kick Or VIOLET (-) At Headlight Switch. ** Door Lock Module Available ------------- Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt
Posted By: chicomax75235
Date Posted: June 22, 2004 at 11:53 AM
ok where do i connect the blue wire on the 557l and where is the body control module
------------- Jose Chapa
Posted By: draasch
Date Posted: June 22, 2004 at 11:55 AM
At the B.C.M. Located Under Drivers Dash
i dont use that brand, what is that part for??? ------------- Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt
Posted By: chicomax75235
Date Posted: June 22, 2004 at 12:05 PM
its a dei,ok i was looking for the b.c.m but cant find a module with six plugs only on with five,medium size black box under the steering colum
------------- Jose Chapa
Posted By: draasch
Date Posted: June 22, 2004 at 1:23 PM
is that unit for the door locks???/ ------------- Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt
Posted By: promodeepcycle
Date Posted: June 22, 2004 at 2:09 PM
that is the bcm databus connectson the obd2 connector on the underdash at least 6 inches back from the connector that is for door locks the only thing you grab at the bcm is door triggers i think that module is an old remotestart add on ?? well good luck ------------- dont be a pet monkey ..use your dmm
Posted By: joseph25
Date Posted: June 27, 2004 at 10:45 PM
If you're refering to the blue/black (-) status input on the 555L then you connect it to the (-) status output of the Directed remote start system. This wire is blue or blue/black also. The BCM (Body Control Module) is under the driver side dash. It has 6 plugs in it, the purple plug is on the back. I'm going to try to copy/paste the vehicle info for your vehicle in this reply. Hope it works... - DON'T go near yellow SRS airbag looms. Don't touch them! Cutting or probing these wires may cause unintentional airbag deployment, electrical system damage or injury.
- DON'T use any other testing tools besides the digital multimeter. No test lights!
- Use of a test light may cause unintentional deployment of vehicle airbag, electrical system damage or injury.
- DON'T crimp. Please solder all connections. Sound connections are required for proper unit functioning.
- Run your wires away from all moving parts and heat sources.
- Read the entire manual and watch the entire video before starting.
- Run wires only through holes that have rubber grommets. Failure to comply may compromise wire insulation integrity.
- Use a ring terminal for ground.
- DON'T ground to a factory bolt - refer to the manual for proper grounding.
|
12volts | red (x2) | + | ignition harness | Starter | yellow | + | ignition harness | Second Starter | N/A | | | Ignition | pink | + | ignition harness | Second Ignition | white | + | ignition harness | Notes for this item : To avoid the check engine light from coming on and possible damage to the automatic transmission, the second ignition in this vehicle MUST be powered when adding a remote start system. | Third Ignition | N/A | | | Accessory | orange | + | ignition harness | Second Accessory | brown | + | ignition harness | Keysense | lt. green | - | ignition harness | Power Lock | use Directed module 456G | | | Notes for this item : If Directed module 456G is not available, refer to DirectFax document 1601. On base model trucks the lock wire is lt. blue (-), pin B5, and unlock wire is white (-), pin B10. They are in the lt. blue plug at the BCM. | Power Unlock | see power lock | | | Lock Motor | gray | | driver door module in door | Unlock Motor | tan | | driver door module in door | Parking Lights+ | do not use | | | Parking Lights- | gray/black | - | brn plug, pin B2 @ BCM | Notes for this item : The BCM (Body Control Module) is under the driver side dash. It has 6 plugs in it, the purple plug is on the back. | Hazards | white | - | steering column, 5 pin plug | Turn Signal(L) | green | + | steering column, 5 pin plug | Turn Signal(R) | lt. green | + | steering column, 5 pin plug | Reverse Light | lt. green | + | blk plug, pin F @ BCM | Notes for this item : The BCM (Body Control Module) is under the driver side dash. It has 6 plugs in it, the purple plug is on the back. | Door Trigger | gry/blk (L), blk/wht (R) | - | each door module in door | Notes for this item : On base model trucks the door trigger wires are in the lt. blue plug at the BCM, pins B4 and A5. On 4dr trucks the LR door trigger is lt. blue/black, pin A3, and the RR is lt. GREEN/ black, pin A2. They are in the purple plug at the BCM. Use all wires and diode isolate.
The BCM (Body Control Module) is under the driver side dash. It has 6 plugs in it, the purple plug is on the back. | Dome Supervision | gray/black | + | BCM, black plug, pin E | Notes for this item : The BCM (Body Control Module) is under the driver side dash. It has 6 plugs in it, the purple plug is on the back. | Trunk/Hatch Pin | N/A | | | Hood Pin | N/A | | | Trunk/Hatch Release | N/A | | | Power Sliding Door | N/A | | | Factory Alarm Arm | arms with lock | | | Factory Alarm Disarm | lt. green | - | driver door module in door | Disarm No Unlock | see factory alarm disarm | | | Tachometer | white | ac | instrument cluster or PCM | Notes for this item : The PCM (Powertrain Control Module) is in the left front of the engine compartment to the left of the fan shroud. The tach wire is in the green plug, pin 10.
For tach can also go to any of the ignition coils or injectors and use the wire that is NOT pink, black, or brown. | Wait to start | blue | - | instrument cluster or PCM | Brake Wire | white | + | brake pedal switch | Parking Brake | lt. blue | - | lt. blu plug, pin A7 @ BCM | Notes for this item : The BCM (Body Control Module) is under the driver side dash. It has 6 plugs in it, the purple plug is on the back. | Horn Trigger | BLACK / YELLOW to black | - | steering column | Memory Seat 1 | red | + | driver door module in door | Memory Seat 2 | pink | + | driver door module in door | Memory Seat 3 | N/A | + | |
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter. Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information. |
Hope this helps, Joe
Posted By: chicomax75235
Date Posted: July 05, 2004 at 11:05 AM
Ok,Has anyone tried this i was thinking if with the a remote start when one that you can connect the auxiliry chanel to rev up the engine due to the new silverado have electric throtle plate.if so has anyone done this i think it would be real cool
------------- Jose Chapa
Posted By: sub sonic
Date Posted: July 05, 2004 at 11:58 AM
the only problem i see with that (that is if i clearly understand what your trying to say is.....) most remote start units are designed to shut down if it sees a tach signal much stonger than that orignally programed. know what i mean?
------------- gill secure
Posted By: chicomax75235
Date Posted: July 29, 2004 at 2:05 PM
where should i connect the wire wich lets the alarm know that the door is open because know i have it connected to the dome light wire and with the door open the alarm arms
------------- Jose Chapa
Posted By: raydawg357
Date Posted: July 29, 2004 at 2:26 PM
In the light blue harness, connect the grey/black for the driver's door and the BLACK/ white wire for the passenger door. You will have to diode isolate the door trigger wire from the alarm. The wires are in positions A4 and B5 and are (-). ------------- Do it right the first time
Posted By: chicomax75235
Date Posted: July 29, 2004 at 9:28 PM
wheres the light blue harness at,why does it need to be diode
------------- Jose Chapa
Posted By: chicomax75235
Date Posted: August 16, 2004 at 10:44 AM
I have a question when i remote start my 2003 silverado the stereo does not turn on?dos dis happen to all the remote start veichles? ------------- Jose Chapa
Posted By: tonyIrv
Date Posted: August 16, 2004 at 10:45 AM
My radio comes on when I remote start my truck.
Posted By: tonyIrv
Date Posted: August 16, 2004 at 10:46 AM
Forgot to add, my truck is a 2001 Tahoe.
Posted By: profuse007
Date Posted: August 16, 2004 at 10:58 AM
| IGNITION|pink (12 awg) |+ |ignition harness | | SECOND IGNITION|white |+ |ignition harness | | ACCESSORY|orange |+ |ignition harness | | SECOND ACCESSORY|brown |+ |ignition harness
check to see if you power up all the wires, mostlikely one of the accessory wire.
if not, its required a relay to power up the second acc.
------------- Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).
Posted By: chicomax75235
Date Posted: August 17, 2004 at 3:01 PM
thanks i checked and i had forgot to connect the brown wire/second accesory on ignition harness to the alarm,connected now works,ots weird due to a friend has the same truck and he got his alarm professionaly installed and his stereo does not come on,also my brother in law has the same alarm on a 2003 dodge ram and he got his installed at car toys and his stereo does not come on also,i got mine fixed thanks
------------- Jose Chapa
|