Automate and 551t remote start problems

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=34774
Printed Date: May 28, 2024 at 10:04 PM

Topic: Automate and 551t remote start problems

Posted By: my68ur8trd
Subject: Automate and 551t remote start problems
Date Posted: June 29, 2004 at 12:05 AM

installed a older 551t with an older automate 410. if the alarm is armed and the remote start is started, the alarm goes off. i did not connect the status or accessory wire to anything. i wasnt sure where to connect them. please help

Justin

Replies:

Posted By: sroth140
Date Posted: June 29, 2004 at 1:43 AM

you have to isolate the shock harness during remote start. im not sure about what to do with the automate, but if the alarm has an external shock sensor, you can use a relay to interrupt the (+) or (-) wire on the sensor to cut power to it.

-------------
MECP certified installer

Print Page | Close Window