Print Page | Close Window

factory remote

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=34867
Printed Date: May 12, 2025 at 11:16 AM


Topic: factory remote

Posted By: draasch
Subject: factory remote
Date Posted: June 30, 2004 at 6:32 PM

does anyone know on a 93 Mercury Sable how to program factory transmitter???? i know where the unit is, how ever the info i have doesnt match up to the unit......there is no two wire plug at the K/E unit......any help would be great...



thanks,
david

-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt




Replies:

Posted By: Scott35
Date Posted: June 30, 2004 at 7:52 PM
Hey David, Here is what I have:Turn ignition to run or acc. Momentarily jump pins in programming connector located in L/R qtr panel area. All doors will lock then unlock to confirm programming mode. Press any button on 1st transmitter. Door locks will cycle to confirm programming. Press any button on 2nd remote. Turn ignition to off. Locks will again cycle to indicate end of programming mode.

-------------
Tacomacrew


Print Page | Close Window