Printer Friendly Forum Posts - keyless entry on 2004 Celica GT

Hello everyone, I need to install a Bulldog Keyless Entry system on my shiny new 04 Celica Gt. The Bulldog website lists a wiring schematic, but I was wondering, since this car is offered with a dealer installed Toyota k/e system, is there perhaps a DIN plug located somewhere in the vehicle, so that instead of splicing wires on my steering column wiring harness, I could simply clip the wires at the DIN plug? Thank you for any help you can offer. PS - I realize that I could take the car to a Pro, but there would be no fun in that.......

DIRECTWIRE™ WIRING INFORMATION - TOYOTA / CELICA / 2004 / Security
[PRINT THIS PAGE]

12volts	BLACK/ red and white	+	ignition harness
Starter	BLACK/ white	+	ignition harness
Ignition	BLACK/ orange	+	ignition harness
Notes: When doing remote start, this wire must be isolated from the keyswitch with the ignition relay. See DirectFax document 1077 for wiring information.
Power Lock	brown	-	passenger kick or BCM
Notes: The BCM (Body Control Module) is located just to the right side of the radio. Remove the radio to access.
Power Unlock	yellow/black	-	passenger kick or BCM
Notes: The BCM (Body Control Module) is located just to the right side of the radio. Remove the radio to access.
Lock Motor	blue/white	5wi	driver kick or BCM
Notes: The BCM (Body Control Module) is located just to the right side of the radio. Remove the radio to access.
Unlock Motor	blue	5wi	driver kick or BCM
Notes: The BCM (Body Control Module) is located just to the right side of the radio. Remove the radio to access.
Disarm Defeat	blue/red	5wi	passenger kick or BCM
Notes: The BCM (Body Control Module) is located just to the right side of the radio. Remove the radio to access.
Parking Lights+	use negative wire
Parking Lights-	lt. green	-	steering column
Hazards
Turn Signal(L)
Turn Signal(R)
Door Trigger	RED / white	-	driver kick panel
Notes: To avoid dome light delay, use RED / yellow at the driver door pin for the driver door and red at the passenger door pin for the passenger door. Isolate each door trigger with diodes.
Dome Supervision	use door trigger
Trunk/Hatch Pin	lt. green	-	trunk light or BCM
Notes: The BCM (Body Control Module) is located just to the right side of the radio. Remove the radio to access.
Hood Pin
Trunk/Hatch Release
Power Sliding Door	N/A
Factory Alarm Arm	arms with lock
Factory Alarm Disarm	disarms with unlock
Disarm No Unlock
Tachometer	BROWN / white	ac	rear of instrument cluster
Horn Trigger	blue/black	-	steering column or BCM
Notes: The BCM (Body Control Module) is located just to the right side of the radio. Remove the radio to access.
Memory Seat 1
Memory Seat 2
Memory Seat 3

Immobilizer Bypass Module:	Required: No	Type: N/A	Part #: N/A
Notes: N/A

This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.