hi:
having trouble finding the door pin wire can anyone help me out?
also what ohm resistor do i use for the park lights?
thanks
-------------
604
In the driver a pillar you can use the yellow/light blue wire for positive door trigger. You can find a WHITE/ light gray wire near the dirver kick for positive parking lights no resistor needed.
Door trigger: The driver door trigger is purple and the driver side rear door is PURPLE / orange. These wires are in the driver kick panel. The passenger door trigger is PURPLE / white and the passenger side rear door is purple / YELLOW. These wires are in the passenger kick panel. Use all four wires and diode isolate each.
Parking light: WHITE/ yellow (L) and WHITE/ gray (R) @ harness at top of driver fender
or : PURPLE / yellow at the headlight switch (Parking Lights Need To See A Ground (-) Through A 330 Ohm Resistor)
Separate Triggers For Each Door. The Driver's Door Trigger Is Tan (-). The Left Rear Door Trigger Is Tan/Orange (-). Both Wires Can Be Found In The Driver's Kick Panel. The Passenger Front Door Trigger Is Tan/Red (-) And the Passenger Rear Door Trigger Is Tan / YELLOW (-). Both Of These Wires Can Be Found In The Passenger Kick Panel. Diode Isolate Each Wire For Alarm Trigger With The Bands Facing Away From The Alarm/Remote Start Module
sorry about that... he it is again...
Parking light = 18g. WHITE/ light gray at white connector above drvier kick.
Door trigger =
Driver = 18 g VIOLET at white connector above driver kick
Driver Rear Door = 18 g VIOLET/GRAY at white connector above driver kick
Front Passenger = 18 g VIOLET/WHITE at left of steering column leading up to gauges (Pop out light switch for better view and lighting)
Rear Passenger = 18 g VIOLET / YELLOW at same as Front Passenger
-------------
Always More To Learn!!!
Parking light = 18g. WHITE/ light gray at white connector above drvier kick.
I usually use this wire too as stated above. Just keep in mind that it only powers up the external parking lights and not the dash lights.