Help with dei 451 m on lancer evo
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=35134
Printed Date: May 09, 2024 at 3:10 AM
Topic: Help with dei 451 m on lancer evo
Posted By: ek9jdmhb
Subject: Help with dei 451 m on lancer evo
Date Posted: July 06, 2004 at 3:54 PM
First off i would like to say hello. I have been reading this forum for about 2 weeks, trying to figure out if i wanted to sell my viper690xv for a compustar. I decided to keep the viper since I had warranty on it. OK, now here is the situation. I got the viper from circuit city and about a month later, I was having problems with it so I decided to send it back to viper, and upon removal, I noticed that these guys did not solder anything!. Not event the constant 12v or the wire going to the starter. Also, the kept the antenna under the dash and used wire splices. After seing this crappy job, I decied I wanted to install it myself. I took everything out, from the brain to the harnesses. I sent everything back in. When i recieved it, I installed it myself (i was hesitant but this board made me feel more confidant), but realized I didnt have the door lock relay. Well I jsut bought it and have been trying to read up on this, but it is way to confuzing for me. can anyone help me out? When i disconnected it, I thought there were less wires. this one has 3 wires to the brain, and five out. Does anyone know what to do with those five?
Replies:
Posted By: ek9jdmhb
Date Posted: July 06, 2004 at 4:02 PM
Sorry, heres some info. MY CAR | ITEM | WIRE COLOR |POL| WIRE LOCATION |
| 12V |white |+ | ignition harness |
| STARTER |BLACK / YELLOW |+ | ignition harness |
| IGNITION |BLACK/ white |+ | ignition harness |
| ACCESSORY |blue/black |+ | ignition harness |
| POWER LOCK |purple |- | driver kick panel |
| POWER UNLOCK |lt. green |- | driver kick panel |
| PARKING LIGHTS + |GREEN / WHITE | | wht plug bottom of fuse box |
| DOOR TRIGGER |white |- | wht plug bottom of fuse box |
| DOME SUPERVISION |use door trigger | | |
| TRUNK/HATCH PIN |GREEN/ orange |- |light in trunk | 451M Violet, Violet/Black - High current constant 12V+
Blue/Black - Motor side of unlock wire
BROWN / Black - Switch side of unlock wire
GREEN/ Black - Motor side of lock wire
WHITE/ Black - Switch side of lock wire
Posted By: datrick
Date Posted: July 06, 2004 at 4:22 PM
here you go: Violet, Violet/Black - Both to ground (15 ampere fuse)
Blue/Black - To the lt.green wire of your car (unlock) BROWN / Black - Not used GREEN/ Black - To the purple wire of your car (lock) WHITE/ Black - Not used
Posted By: datrick
Date Posted: July 06, 2004 at 4:23 PM
here you go: Violet, Violet/Black - Both to ground (15 ampere fuse) Blue/Black - To the lt.green wire of your car (unlock) BROWN / Black - Not used GREEN/ Black - To the purple wire of your car (lock) WHITE/ Black - Not used
Posted By: auex
Date Posted: July 06, 2004 at 8:10 PM
Why use the 451M? It is not neccesary on your vehicle.
-------------
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.
I've been sick lately, sorry I won't be on much.
Posted By: JWorm
Date Posted: July 06, 2004 at 11:05 PM
The 451m is pointless in your car. The blue unlock wire from the 690 goes to the lt. green unlock wire in the car. The green lock wire from the 690 goes to the purple lock wire in the car.
Posted By: ek9jdmhb
Date Posted: July 07, 2004 at 12:05 AM
what about the red wire? Where does that go?
Posted By: ek9jdmhb
Date Posted: July 07, 2004 at 12:41 AM
also, when would you use the 451m? Oh, and thanks for everyone who helped me out.
|