remote start 91 s-10

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=35320
Printed Date: May 20, 2024 at 4:16 AM

Topic: remote start 91 s-10

Posted By: heschlie
Subject: remote start 91 s-10
Date Posted: July 09, 2004 at 9:51 PM

hey ok i got all the wiring done to what i believe is supposed to be, but when i press the button to remote start it lights up the dash, and the fuel pump goes on but it doesnt crank. i have a panther ps-5000 and it has the remote start built in, i cant find, or know if there is a neutral safety wire on the alarm, and when i test the voltage coming out of the brain for the starter wire it doesnt change, whats going wrong?

Replies:

Posted By: heschlie
Date Posted: July 10, 2004 at 12:18 AM

ok great now im lost, i just went to plug my brain back up and try again and now it blinks but it wont transmit to the remote! is it pretty much not worth installing at this point? or should i try to get a replacment?

Posted By: Javelin3o4
Date Posted: July 10, 2004 at 4:03 AM

most alarms require a neutral safety switch wire be hooked up in order for it to remote start, that wire usually needs to see ground in order for the remote start to work, also some require a hood pin hooked up that way if the hood is popped while the car is remote started the alarm will shut off. Did you cut your starter wire to install a started disable? if you did you connect the wires to the right side? some will say cut the starter wire then connect this color wire of the relay to the key side of the starter wire, then connect the other wire to the starter side of the wire.

Posted By: heschlie
Date Posted: July 11, 2004 at 5:05 AM

thanks for the info, but my problem was that this alarm didnt have that sensor, could it be the handbrake/turbo or something rather to that effect? well anywho the alarm is toast and im not quite sure why at the point, it wont transmit and the antenna is hot, i checked and it looks like a capacitor on the antenna went bad, i dunno i think im gonna get a better alarm system. thanks again for the info.