need help on alarm install 93 grand cherokee

I'm lost so if any geniuses out there can help me figure out what alarm wire goes with what jeep wire I'll Paypal you a few dollars for the help. Here is a link for the complete install in adobe format

https://www.unitedmicroprinting.com/Amir/Amir/dtexx.htm

18 Pin Harness:

• 1. Black : Ground to chassis
• 2. Blue : YELLOW (-) at drivers kick panel .
• 3. BLACK/ Red : NOT USED
• 4. BLACK / YELLOW : Starter Kill trigger wire
• 5. Yellow/Red : Connects to an AUX relay that will control a device of your choice.
• 6. Grey/Black : Connect to the GREY/BLUE wire found on the passenger side firewall under hood
• 7. Blue/Red : NOT USED
• 8. ORANGE / White : NOT USED
• 9. Purple : ?????
• 10. GREEN/ Black : Use the BLUE/RED at the left of steering column.
• 11. GREEN/ YELLOW : NOT USED
• 12. BLACK/ White : Attach to PURPLE / YELLOW wire
• 13. Grey : To siren wire at the driver kick panel ( black plug )
• 14. Yellow/Blue :
• 15. Yellow/Black: NOT USED
• 16. ORANGE / Violet : Atatch to the brake (-) of the e-brake found on the drievr side
• 17. Blue/Black : Attach to the YELLOW wire (-) at drivers kick panel ( same connection as the dome light )
• 18. ORANGE / Grey :  Attach to the hood pin switch

6 Pin Connector:

• 1. BLACK / YELLOW : Connect to yellow/blue (small)  at the steering column
• 2. Blue : Connect to the ORANGE / black at the steering column
• 3. Red : Connect to pink/blk or RED / wht at the steering column
• 4. Red : Connect to pink/blk or RED / wht at the steering column
• 5. Yellow : Connect to blue/gray  at the steering column
• 6.  Green : Not Used