Matrix 2.5x Hood/Trunk/Tilt Sensor

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=36159
Printed Date: May 02, 2024 at 7:21 AM

Topic: Matrix 2.5x Hood/Trunk/Tilt Sensor

Posted By: djpc80
Subject: Matrix 2.5x Hood/Trunk/Tilt Sensor
Date Posted: July 25, 2004 at 8:40 PM

hi, if anyones familiar with the 2.5x by clifford i have a question about installing a hood/tilt sensor and trunk pin/switch. How can each of them be isolated to go off per zone. For instance in the manual it says the blue wire for trunk/hood pin,instant trigger/zone 1. How would the alarm system be wired to know when the hood goes off and vise versa, and what would you connect the tilt sensor to trigger a diferent zone icon or something to know if thats going off too? Thanks for the help in advance.

Replies:

Posted By: raydawg357
Date Posted: July 27, 2004 at 8:01 AM

You will have to diode isolate each of the different zones so they don't trigger each other.

-------------
Do it right the first time

Posted By: Big Dog
Date Posted: July 27, 2004 at 9:50 AM

Connect the hood switch to the small gray input and the trunk switch to the blue on the main connector. Program the transmitter to see these as two different zones as explained in the owner's manual ( RTFM posted_image

)

-------------
Prepare your future. It wasn't the lack of stones that killed the stone age.