Print Page | Close Window

02 Voyager

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=36196
Printed Date: May 17, 2025 at 12:56 PM


Topic: 02 Voyager

Posted By: meh66
Subject: 02 Voyager
Date Posted: July 26, 2004 at 11:20 AM

Ok,

I have read many post on this alarm and I know I have to put the 180 OHM resistor on a relay and then connect to the second starter wire. However, my friend is now complaining about something else. She said when she turns the car on, her wipers and window sprayer comes on. I am really confused because when I left the car it was not doing that. Hwoever, I do not think it was doing it before I installed the alarm. Can some one provide some assistance. All I would like to do is get the car back to normal. Thanks



-------------
MEH66
"Car Performance and Mobile Electronic Enthusiats"



Replies:

Posted By: sparkie
Date Posted: July 26, 2004 at 3:44 PM
If you have used a negative out when running wire to activate more than one relay, you need to diode isolate it if there is more than one circuit running off of it. you may be getting a feedback problem through the coils of the relays if you haven't done this. This can accidentely cause circuits to receive power when they shouldn't. Unplug all your relays and see if the problem goes away.

-------------
sparky


Print Page | Close Window