2001 Grand am alarm
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=36682
Printed Date: July 18, 2025 at 4:07 PM
Topic: 2001 Grand am alarm
Posted By: FrozenTundra
Subject: 2001 Grand am alarm
Date Posted: August 03, 2004 at 7:01 AM
I hava couple of questions:
1) Does anyone have the factory wireing information for the car??
2) I have already started to install an alarm on this car, and while inthe process of locating some wires for the dome light, it stopped working. It never comes on at all, not with the manual switch or with the doors. I was not probing the wires with anything when it happend, almost like a fuse went, but I checked all of them.
3) I can't seem to figure out how to hook up the door pin whitch to the car alarm any tips??
Thanks in advance!!
Replies:
Posted By: raydawg357
Date Posted: August 03, 2004 at 7:37 AM
12volts | red | + | ignition harness | Notes: Remove the radio, without unplugging it, to access the ignition harness. | Starter | yellow | + | ignition harness | Notes: Remove the radio, without unplugging it, to access the ignition harness. | Second Starter | | | | Ignition | pink | + | ignition harness | Notes: Remove the radio, without unplugging it, to access the ignition harness. | Second Ignition | dk. green | + | ignition harness | Notes: Remove the radio, without unplugging it, to access the ignition harness. | Third Ignition | | | | Accessory | orange | + | ignition harness | Notes: Remove the radio, without unplugging it, to access the ignition harness. | Second Accessory | brown | + | ignition harness | Notes: Remove the radio, without unplugging it, to access the ignition harness. | Keysense | | | | Power Lock | white | - | black plug in dkp | Notes: Lock requires a negative trigger, and unlock requires a negative trigger through a 1,500 ohm resistor. Must use relays. Must close doors to lock with a single pulse. | Power Unlock | same wire | | | Lock Motor | gray | | drivers kick panel | Unlock Motor | tan | | drivers kick panel | Parking Lights+ | brown | | passenger kick or column | Parking Lights- | | | | Hazards | | | | Turn Signal(L) | | | | Turn Signal(R) | | | | Reverse Light | | | | Door Trigger | | - | | Notes: The lt. GREEN/ black is located in the drivers kick and catches only the drivers door. The lt. blue is located in the harness coming from the drivers running board going under the drivers seat and it catches all other doors. Use both door trigger wires and diode isolate each. On the 2 door the lt.blue is in the passenger kick. | Dome Supervision | white | - | dash light or column | Trunk/Hatch Pin | ORANGE / black | - | trunk light | Hood Pin | | | | Trunk/Hatch Release | BLACK/ white | + | drivers kick panel | Power Sliding Door | | | | Factory Alarm Arm | | | | Factory Alarm Disarm | | | | Disarm No Unlock | | | | Tachometer | white or PURPLE / wht | | ignition coil or ECM | Notes: The ECM is located under the left side of the dash to the left of the column. | Wait to start | | | | Brake Wire | lt. blue | + | at the switch | Parking Brake | | | | Horn Trigger | black | - | steering column | Memory Seat 1 | | | | Memory Seat 2 | | | | Memory Seat 3 | | | | Immobilizer Bypass Module: | Required: Yes | Type: Passlock 2 | Part #: 555L or 555T | Notes: N/A |
------------- Do it right the first time
Posted By: FrozenTundra
Date Posted: August 03, 2004 at 3:16 PM
Thanks for the wiring information it is much better thatn muddling around tring to find the wires...
Posted By: FrozenTundra
Date Posted: August 03, 2004 at 3:22 PM
I have started to install a alarm on a 2001 pontiac Grand Am, and while inthe process of locating some wires for the alarm, the dome light stopped working It never comes on at all, not with the manual switch or with the doors. I was not probing the wires with anything when it happend, almost like a fuse went, but I checked all of them as well as the bulb... all of them are good...
any Ideas what happened???? or how to trace for a problem???
|